Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Assignment - Product Housing
1. Base on the four layout sketches provided, model "Housing-top" with the following design features:
• Fillets 2mm and 5mm around corners• 2mm wall thickness• 1° draft angle as shown in Fig. (attached).
2. Create a new "Assembly" and insert "Housing-top" into it with origins of both files coincidently aligned.
3. Use the same design features as listed in No."1" above to model "Housing-bottom" under assembly environment.
4. Use the following setting to generate 2D drawing with Section A-A and adequate dimensions as shown in Fig. 2(attached) :• First Angle projection• True scale• A3 landscape paper size• Hatch pattern : ANSI31• Dimension font size = 5mm
5. Assign ABS material to the housings.
6. Check the Center of Mass of the whole assembly. And copy the information to 2D drawing as shown in Fig. 2(attached).
Attachment:- Product Housing.rar
in a cogeneration scheme a diesel engine-generator is used. the diesel engine-generator is rated at 2000 kwe. the
A roller cam is used to impart a periodic motion to the base of the spring-mass system shown in Fig. 4.41. If the coefficient of friction between the mass and the surface is µ find the response of the system using the principle of superposition. D..
in a pharmaceutical plant a copper pipe kc 400 wm.k with inner diameter of 20 mm and wall thickness of 2.5 mm is used
At a certain location, wind is blowing steadily at 10 m/s. Determine the mechanical energy of air per unit mass and the power generation potential of a wind turbine with 60 m diameter blades at that location. Take the air density to be 1.25 kg/m.
a spool of mass m radius r and radius of gyration kg rolls without slipping on an incline whose angle with respect to
what are the properties of petrol that it make particularly suitable for the use as fuel in a motor vehicle.
Determine the load F which the double strap butt joint shown in Figure 1.94 can carry. The rivets are 6 mm in diameter with an ultimate shear strength of 325 MPa. A factor of safety of 8 is to apply.
What is the ratio of the two pitch diameters for each of the two center distances?
a 3000-lb car accelerates under constant power from 60 mileh to 90 mileh on a 0.25 mile straight level test track.
air is considered as an ideal gas. dont use gas table for gas properties just assume that both cv and cp are constants.
A W24×84 structural steel wide-flange beam on a simple span of 30 ft supports a uniformly distributed load of 3.0 kips/ft. Calculate the end rotation of the beam.
A 0,5Kg mass attached linear spring suffress 01 N/m. Determine be naturak frequency of the system in hortz e reapert this calculation for a mass of 50Kg and a suffress of 10N/m and compare your result to that of part.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd