Constant pressure and through pump and turbine adiabatically

Assignment Help Mechanical Engineering

Reference no: EM13713303

The schematic of a power cycle using water flowing each component is shown. Water flows through the boiler and condenser at constant pressure and through the pump and turbine adiabatically.

Process 4-1: constant pressure at 1 MPa from saturated liquid to saturated vapor

Process 2-3: constant pressure at 20 kPa from x2 = 88% to x3 = 18%. Determine a) is the cycle reversible, irreversible or impossible, b) the thermal efficiency and c) how does this compare with the theoretical maximum efficiency?

Reference no: EM13713303

Questions Cloud

What is the steam quality exiting the low pressure turbine : Reheat is added to an ideal Rankine steam power cycle to improve it’s efficiency and turbine exit quality. Steam enters the HP turbine at 15 MPa and 600C. Steam exits the HP turbine at 4 MPa and enters the boiler for reheat. Then the steam enters t..

Denver colorado is constructed with a slab-on-grade floor : A building in Denver Colorado is constructed with a slab-on-grade floor. The construction type is an uninsulated 100-mm block wall with a brick face. The perimeter of the building is 350m. Calculate the design heat loss rate from the floor.

What is minimum power required to run the air conditioner : An air conditioner maintains the temperature of a dwelling at 72 degrees Fahrenheit when it is 96 degrees Fahrenheit outside. If heat is transferred through the walls and ceiling at 35,000 BTU/hr. a) What is the minimum power required to run the Air..

Explain the mechanisms and genetic regulation : Describe the mechanisms and genetic regulation that underpin how two cells such as a cardiomyocyte and a motor neuron have identical genomes, yet are functionally and structurally different.

Constant pressure and through pump and turbine adiabatically : The schematic of a power cycle using water flowing each component is shown. Water flows through the boiler and condenser at constant pressure and through the pump and turbine adiabatically.

Piston-cylinder undergoes a carnot power cycle : A gas in a piston-cylinder undergoes a Carnot power cycle. The gas expands and compresses isothermally between two reservoirs at 600 K and 300 K. Determine a) the thermal efficiency, b) the percent change in the thermal efficiency if i) the hot reser..

Calculate the overall alloy composition : Micro structural analysis of a slowly cooled Al-Si alloy indicates there is a 6 volume % silicon-rich proeutectic phase. Calculate the overall alloy composition (in weight percent).

Weighted cost of capital calculation for the firm : What is the major value of the weighted cost of capital calculation for the firm and describe capital structure and how is the firm''s weighted cost of capital influence by the firm''s capital structure?

Find pitch radii and the number of teeth in pinion and gear : A gear system having velocity ratio of 4 is connected by spur gears and has a 5-inch in center distance. The diametral pitch P is to be 6 T/in and the pressure angle is 20 degrees

User Account

All Pages