Consists of domains with magnetization parallel to the field

Assignment Help Mechanical Engineering
Reference no: EM13706678

Cobalt has a saturation magnetization of 1.4*10^6 A/m, and an atomic volume of 6.7 cm^3/mole. (a) What is the magnetic dipole moment of each cobalt atom in Bohr magnetons? (b) You apply a magnetic field in the easy direction with a coil of 10 turns per meter carrying a current of 0.3 milliamps, and determine that the total field B within the sample is one tesla. Calculate M and determine what percentage of the volume now consists of domains with magnetization parallel to the field.

Reference no: EM13706678

Questions Cloud

Calculate the delta velocity required to change inclination : Calculate the delta velocity required to change the inclination of a circular orbit at 32,000 km altitude from a 28.5 degree inclination to an inclination of 45 degrees. Compute the propellant used if the satellite weighs 1200 lbs after the maneuver.
Assume sea level pressure : Moist air at 70 F dry bulb temperatures and 45 percent relative humidity is recalculated from a room and mixed with outdoor air at 97 F dry-bulb temperature and 83 F thermodynamic wet bulb temperatures. Determine the mixture state dry-bulb and wet-bu..
Determine the relative humidity : Air with a dry bulb temperature of 38°C and a dew point temperature of 20 °C is at a barometric pressure of 93.1 kPa. Without making use of the psychrometric chart for the given moist air determine the relative humidity
Velocity required in changing position of satellite in orbit : Calculate the change in velocity required in changing the position of a satellite in an orbit by 90 degrees. The initial and final orbit is circular around the Earth with a 15000 km radius. Calculate the delta velocity, semi-major axis and period for..
Consists of domains with magnetization parallel to the field : Cobalt has a saturation magnetization of 1.4*10^6 A/m, and an atomic volume of 6.7 cm^3/mole. (a) What is the magnetic dipole moment of each cobalt atom in Bohr magnetons? (b) You apply a magnetic field in the easy direction with a coil of 10 turns p..
Calculate velocity of satellite in orbit around the earth : Calculate the velocity of a satellite in orbit around the earth in a geosynchronous orbit. Use the definition of a sidereal day which is 86164.09 sec. What is the orbit height in km?
Lifting cylinder in cross flow of radius : Given a lifting (rotating) cylinder in cross flow of radius a with a lift coefficient of C1=5, calculate the peak (suction) pressure coefficient, Cp. Use potential flow relations and assume 2-D.
The work and heat transfer in the process : A rigid tank A of volume 0.6 m^3 contains 3 kg of water at 120 degrees C, and rigid tank B has a volume of 0.4 m^3 with water at 600kPa and 200 degrees C. The tanks are connected to a piston/cylinder initially empty with closed valves.
Determine the thickness of inside diameter pilot sphere : Determine the thickness of the 1.09m inside diameter pilot sphere (assume 4130 steel with ultimate tensile strength of 1,234MPa and a 200% factor of safety). The depth at which the sphere will fall is 10,908 meters.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A blower develops 750mm of water gauge at a speed of

a blower develops 750mm of water gauge at a speed of 1480rpm and a flow rate of 38cubicmeter per sec. determine the

  Draw the pressure vessel large enough to show orientation

A cylindrical pressure vessel of 120 in diameter outside, used for processing rubber, is 36 ft. long. If the cylinder portion of the vessel operates at 120 psi internal pressure, what are the stresses acting on an element at the inside surface of the..

  When the efficiency of an otto cycle will approach that of

when the efficiency of an otto cycle will approach that of carnot cycle? even with nest possible arrangements the

  What are the minimum value of the magnitude ratio and the

a pressure transducer has a natural frequency of 50 khz and a damping ratio of 0.4. it is to be used to measure

  If the initial temperature of the product is 7degc compute

a liquid food is being heated in a tubular heat exchanger. the inside pipe wall temperature is 110degc. the internal

  A slender rod is at rest in vertical position with lenght

a slender rod is at rest in vertical position with lenght of 1.5m. then a force of 50 n. is applied at the bottom tip.

  Bananas are to be cooled from 24degc to 13degc at a rate of

bananas are to be cooled from 24degc to 13degc at a rate of 215 kgh by a refrigeration system. the power input to the

  Determine the pressure in the gas main if the pressure in

natural gas methane flows from a 33-in diameter gas main through a 1-in-diameter pipe and into the burner of a furnace

  Calculate the height h to which the ball rises

A ball is thrown vertically up with a velocity of 91 ft/sec at the edge of a 190-ft cliff. Calculate (a) the height h to which the ball rises and (b) the total time t after release for the ball to reach the bottom of the cliff.

  1 write a program that takes the image tracksjpg and finds

1 write a program that takes the image tracks.jpg and finds canny edges and then finds lines in these edges using the

  Find the percent of volume change after a cube specimen is

if an isotropic material has a poissonamp39s ratio v. find the percent of volume change after a cube specimen is

  If a stream function and a velocity potential exist sketch

a velocity field is givenu ax2 - y2v -2axyw 0a. determine if this is a flow.b. if it is a flow determine an

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd