Considering the maximum normal stress theory

Assignment Help Mechanical Engineering

Reference no: EM13704010

A machine component of square cross- section is subjected to a direct tensile of 20 kn and a shear load of 10 kN. Considering the maximum normal stress theory and distortion energy theory of failure calculate the dimension of the component. Take factor of safety as 2.1.

Reference no: EM13704010

Questions Cloud

Natural uranium are split between enriched-depleted streams : The U-235 and U-238 masses in natural uranium are split between enriched and depleted streams as a result of an enrichment process. If the input masses and output enrichments are specified, mass conservation determines the maximum (i.e. zero-loss) qu..

A piston-cylinder filled with air receives : A piston-cylinder filled with air receives 10 kJ of heat and expands, doing 5 kJ of work. What is the change in internal energy of the air?

Shaft of a rolling machine is driven by means of a motor : The shaft of a rolling machine is driven by means of a motor placed horizontally. The flywheel which also acts as a pulley is of 1.5 m diameter and has belt tension 5.4 kn and 1.8 kn on tight and slack side respectively.

Milk of magnesia a suspension of mg(oh)2 in water : Milk of magnesia, a suspension of Mg(OH)2 in water, reacts with stomach acid (HCl) in a neutralization reaction.

Considering the maximum normal stress theory : A machine component of square cross- section is subjected to a direct tensile of 20 kn and a shear load of 10 kN. Considering the maximum normal stress theory and distortion energy theory of failure calculate the dimension of the component. Take fact..

No change compared to the actual valve : Using an Erlenmeyer flask with 2ml of water instead of 50ml, would it make the experimental molarity higher, lower or no change compared to the actual valve?

Total heat flow through the copper-fiberglass combination : One side of a copper block 5 cm thick is maintained at 250*C. The other side is covered with a layer of fiberglass 2.5 cm thick. the outside of the fiberglass is maintained at 35*C, & the total heat flow through the copper-fiberglass combination is 5..

Diameter sphere is heated to a temperature : A 4.0 cm diameter sphere is heated to a temperature of 200 C & is enclosed in a large room at 20 C. Calculate the radiant heat loss if the surface emissivity is 0.6.

What is the temperature change of the water : Liquid water at 26.67°C flows in a straight horizontal pipe in which there is no exchange of either heat or work with the surroundings. Its velocity is 40 ft/seg in a pipe with an internal diameter of 2.54 cm until it flows into a section where the p..

User Account

All Pages