Consider the pumps and turbines to operate adiabatically

Assignment Help Mechanical Engineering
Reference no: EM13636080

A Rankine cycle with regeneration has one open and one closed feedwater heat. Steam leaves the boiler at 1400psi, 1000°F and expands to 500 psi where a portion of the steam is extracted to the closed feedwater heater. Condensate exits the closed feedwater heater saturated at 500 psi and is trapped into the open feedwater heater operating at 120 psi. The feedwater leaves the closed feedwater heater at 1400 psi at a temperature equal to the saturation temperature at 500psi. The remaining steam expands through the second stage turbine to 120 psi where some of the steam is extracted to the open feedwater heater. Saturated liquid exits the open feedwater heater. The remaining steam expands through the third state turbine to the condenser which is operating at a pressure of 2 psi. Consider the pumps and turbines to operate adiabatically and to all have isentropic efficiencies of 85%. The net power output of the cycle is 1 x 109 Btu/hr. Calculate:

a) the mass flow rate of steam through the first turbine
b) the rate of heat transfer in Btu/hr to the into the steam generator
c) the thermal efficienc

Reference no: EM13636080

Questions Cloud

Use the van der waals equation to calculate pressure p and : assume that one mole of ar has a volume v 2.5 x 10-3 m3 at 300k. use the van der waals equation to calculate pressure
The vessel is heated until the water pressure reaches 8 mpa : a closed rigid pressure vessel is filled with a saturated mixture of 1.78 kg of liquid water and 0.22 kg of water vapor
In a 2010 survey 58 of generation y geny adults were found : in a 2010 survey 58 of generation y geny adults were found to pay their monthly bills on time. suppose a member of geny
Draw the triangles of velocities for inlet and outlet and : a jet of water having a velocity of 40 ms impinges on series of vanes moving with a velocity of 20 ms. the jet makes an
Consider the pumps and turbines to operate adiabatically : a rankine cycle with regeneration has one open and one closed feedwater heat. steam leaves the boiler at 1400psi
A new extended lightbulb has an average service life of : a new extended lightbulb has an average service life of 750 hours. with a standard deviation of 50 hours. if the
What is the gage pressure at the bottom of the tanks in kpa : sea water specific gravity 1.03 leaks into the diesel fuel specifc gravity 0.81 tanks of a ship. diesel fuel and
He mercury manometer shown here is used to measure this : orifices are commonly placed in flow lines to measure the flow rate through the line. the flow rate is proportional to
A machine is found to vibrate with simple harmonic motion : a machine is found to vibrate with simple harmonic motion at a frequency of 20hz and an amplitude of acceleration of

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  The old style heating uses steam or hot water in an

the old style heating uses steam or hot water in an radiator to heat a room in winter time. a radiator can be

  Overlay the frequency spectrum of the excitation

Sketch the frequency response of the system. Overlay the frequency spectrum of the excitation and as you start the system up, increasing Ω from 0 to 60 rpm, what speeds are most likely to excite large amplitude response? Why?

  A household refrigerator with a cop of 12 removes heat

a household refrigerator with a cop of 1.2 removes heat from the refrigerated space at a rate of 60 kjmin. determine a

  Determine the magnitude of the resultant force acting at a

The roof is supported by cables. If the cables exert FAB = 100N and FAC = 120N on the wall hook at A, determine the magnitude of the resultant force acting at A.

  Assuming complete combustion and the pressure of the

one kilogram of butane c4h10 is burned with 25 kg of air at 30 degrees celcius and 90 kpa. assuming complete combustion

  Determine the force on the guinea pig in n that caused it

a large guinea pig weighing 2 kg is riding a skateboard horizontally at a speed of 25 ms. then a force causes the

  Consider a device with one inlet and one outlet if the

consider a device with one inlet and one outlet. if the volume flow rates at the inlet and at the outlet are the same

  The upper surface of a 50-cm-thick solid plate k237 wmk is

the upper surface of a 50-cm-thick solid plate k237 wmk is being cooled by water with temperature of 20 degrees

  Find the reversible amount of of work per unit mass find

the air with constant properties in a steady adiabatic flow enters a system at a pressure of 10 bars and 500k with a

  What is the percentage error

One side of a right triangle is known to be 45 cm long and the opposite angle is measured as 30?, with a possible error of 1?.

  Compute this maximum height in terms of v0 theta and g note

a cannonball with mass m is fired with an initial speed v0 at an angle theta ablve the horizontal. compute the time it

  1 what happens to the cutting and thrust force as tool rake

1. what happens to the cutting and thrust force as tool rake angle and cutting speed are increased?2. how does the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd