Reference no: EM13704557
Consider a summer air-conditioning system that is required to maintain a room (space) at specified conditions. The layouts of the system as well as the specifications are listed below.
Required room temperature 23C, 50% Relative humidity
Atmospheric pressure 101 kPa
Outside air conditions 30C, 80% Relative humidity
Sensible heat gain for space 5 kW
Latent heat gain for space 4 kW
Temperature of air leaving cooler 12C
Temperature of supply air (entering room) 18C
One-quarter of the mass flow rate entering the room at state 1 (i.e., the supply air) is fresh outdoor air. In other words, one-quarter of the air entering the mixing box is outdoor air, and the other three-quarters is recalculated air.
Determine the following:
The volumetric flow rates of the supply air (supplied to the room) and outdoor air.
The heat removed by the cooling coil.
The heat supplied in the re-heating coil.
|
Three lb of water is contained in a piston–cylinder assembly
: Three lb of water is contained in a piston–cylinder assembly, initially occupying a volume V1 5 30 ft3 at T1 5 300°F. The water undergoes two processes in series: Constant-temperature compression to V2 5 11.19 ft3, during which there is an energy tra..
|
|
Piston cylinder assembly contains a two phase liquid vapor
: A piston cylinder assembly contains a two phase liquid vapor mixture of h2o at 200lbf/in^2 with a quality of 80%. The mixture is heated and expands at a constant pressure until the final temperature of 480 degrees F is reached. Determine the work for..
|
|
What is the shear stress in the fluid at the wall of pipe
: Water is moving through a pipe, and the laminar-flow velocity profile at some section is: V(r) = (Beta/(4*mu))((D^2 / 4) - r^2 ) t, V(r) is the viscosity of water, Beta is a constant, mu is the viscosity of water, D is the pipe diameter, and r is the..
|
|
Thermodynamic analysis-lenoir cycle
: A gas inside a piston-cylinder device completes a three-step forward cycle, called the Lenoir cycle, described as follows: Complete a thermodynamic analysis of this cyclic process defining the system as the gas and neglecting any effect of friction. ..
|
|
Consider a summer air-conditioning system
: Consider a summer air-conditioning system that is required to maintain a room (space) at specified conditions. The layouts of the system as well as the specifications are listed below. Required room temperature 23C, 50% Relative humidity.
|
|
What is the current demand for water
: Presently, benzene vapors are condensed in a heat exchanger using cooling water. The benzene (100 kmol/h) enters at 0.1013 MPa and 120°C, and exits at 0.1013 MPa and 50°C. Cooling water enters at 10°C and exits at 40°C. What is the current demand for..
|
|
Gadolinium metal undergoes polymorphic phase transformation
: Gadolinium metal undergoes a polymorphic phase transformation from HCP to BCC upon heating at 1260oC. The lattice parameters for the HCP phase are a=0.3745 nm and c=1.18525 nm. The lattice parameter for the BCC phase is 0.4060 nm. Calculate the densi..
|
|
Determine the coefficient of thermal expansion
: For integrated circuits, Al lines are commonly placed on Si to act as electrical conductors between different parts of the device. Assuming that the Al is deposited at a temperature of 300oC, determine the CTE (Coefficient of Thermal Expansion) misma..
|
|
Calculate its volume before and after heating
: If a super alloy jet engine is heated so that its length in each direction expands by 1%, what is its percentage change in volume (assume it is roughly cubic)?
|