Conditioning system to acquire-store an egg bio potential

Assignment Help Mechanical Engineering

Reference no: EM13708120

Design a signal conditioning system to acquire and store an EGG bio potential. The bandwidth of interest is between 6 and 120 Hz and has peak amplitude of approximately +/-10 mV.

a. Design and draw a block diagram (not circuit) of the signal conditioning portions (everything before ADC) of your system.

b. Calculate the gain required to optimize you data acquisition into an ADC with input range of +/- 10 V.

c. If you have a 16-bit ADC DAQ-card, what is the resolution of your signal?

d. Is there enough voltage resolution to not require added gain on the bio potential?

Reference no: EM13708120

Questions Cloud

The inner pipe of a double-pipe heat exchanger : The inner pipe of a double-pipe heat exchanger has an OD of 1.9 in. and contains 36 rectangular fins of the type shown in the sketch below. The fins are made of steel (k=34.9 Btu/h ? ft ? ?F) and are 0.5 in. high and 0.035-in. thick.

Plot the mass of ice against the initial temperature of ice : A 0.3-L glass of water at 20°C is to be cooled with ice to 5°C. The melting temperature and the heat of fusion of ice at atmospheric pressure are 0°C and 333.7 kJ/kg, respectively, and the density of water is 1 kg/L.

An insulated tank is divided into two parts by a partition : An insulated tank is divided into two parts by a partition. One part of the tank contains 2.5 kg of compressed liquid water at 60°C and 600 kPa while the other part is evacuated.

Gas is compressed from a state : A gas is compressed from a state of 15 lbf(in)^2, 0.5ft^3, to a final state of 60 lbf/(in)^2. The process equation relating P and V is P=aV+b, where a=-150 lbf/ft^3. Evaluate the work, in ft-lbf.

Conditioning system to acquire-store an egg bio potential : Design a signal conditioning system to acquire and store an EGG bio potential. The bandwidth of interest is between 6 and 120 Hz and has peak amplitude of approximately +/-10 mV. Calculate the gain required to optimize you data acquisition into an AD..

Running conveyor system problem : A random sample of three bottles is selected from the running conveyor system. When the bottles are inspected, they are either properly labeled or they are not. Rejected bottles are scrapped. The proportion nonconforming is 0.25. What is the probabil..

Insulated piston-cylinder-determine voltage of the soured : An insulated piston-cylinder device contains 7L of saturated liquid water at a constant pressure of 175 kPa. Water is stirred by a paddle wheel while a current of 6.2A flows for 75 min through a resistor placed in the water. If one half of the liquid..

Injection molding machine-what is minimum clamp tonnage : The bottom of a chair (where you sit, the ‘seat’) will be injection molded by itself in a mold. Assume the chair is a disk, 24 inches in diameter and 1/10 inch thick. If the injection pressure is 1600 psi, what is the minimum clamp tonnage you need f..

What is the total rate of their heat transfer : Metal balls 10 mm in diameter are to be annealed by heating them to 827°C then allowing them to cool slowly in air at 27Â°C to the point where they are in thermal equilibrium with the air. 2000 balls are annealed in one hour’s time. What is the total..

User Account

All Pages