Concept of beat frequency to tune a musical instrument

Assignment Help Physics

Reference no: EM13561751

Explain how you might use the concept of beat frequency to tune a musical instrument using tuning forks. Would this method work better for an instrument that is slightly out of tune or an instrument that is completely out of tune?

Reference no: EM13561751

Questions Cloud

The time constant of an rc circuit : The time constant of an RC circuit is 2.1 s. How much time t is required for the capacitor (uncharged initially) to gain one-half of its full equilibrium charge?

Bread box on frictionless incline of angle : A 2.0 kg breadbox on a frictionless incline of angle ? = 33° is connected, by a cord that runs over a pulley, to a light spring of spring constant k = 120 N/m, as shown in the figure below. The box is released from rest when the spring is unstrect..

Capacitor that controls this pulsing rate discharges : In a heart pacemaker, a pulse is delivered to the heart 81 times per minute. The capacitor that controls this pulsing rate discharges through a resistance of 2.4 x 106. One pulse is delivered every time the fully charged capacitor loses 63.3% of its ..

How many time constants must elapse before a capacitor : How many time constants (a decimal number) must elapse before a capacitor in a series RC circuit is charged to 60.0% of its equilibrium charge?

Concept of beat frequency to tune a musical instrument : Explain how you might use the concept of beat frequency to tune a musical instrument using tuning forks. Would this method work better for an instrument that is slightly out of tune or an instrument that is completely out of tune?

How much work is done by the normal force : A factory worker pushes a 28.6 kg crate a distance of 4.9 m along a level floor at constant velocity by pushing downward at an angle of 32 degrees below the horizontal. The coefficient of kinetic friction between the crate and floor is 0.26. How m..

Resistance between the ends of the welded bar : Two cylindrical bars, each with diameter of 2.40 cm, are welded together end-to-end. One of the original bars is copper and is 0.350 m long. The other bar is gold and is 0.135 m long. What is the resistance between the ends of the welded bar at 20 oC..

Potential difference between plates-initial stored energy : The parallel plates in a capacitor, with a plate area of 5.80 cm2 and an air-filled separation of 4.90 mm, are charged by a 8.10 V battery. They are then disconnected from the battery and pulled apart (without discharge) to a separation of 6.70 mm..

What is the magnetic force on the section of wire : cA wire carries a steady current of 2.40 A. A straight section of the wire is 0.750 m long and lies along the x-axis within a uniform magnetic field, B=kT. If the current is in the +x direction, what is the magnetic force on the section of wire?

User Account

All Pages