Concentration of titanium in the original unknown solution

Reference no: EM13173998

Cobalt was used as an internal standard to analyze a sample of titanium with atomic absorption spectroscopy. A mixture was prepared by combining a 4.50 mL Ti solution of unknown concentration with 2.00 mL of a 10.5 micrograms/mL solution of Co. The atomic absorbances were measured as 0.106 and 0.214 for Ti and Co, respectively.

As a reference, a standard mixture containing 2.26 micrograms Co/mL and 1.92 micrograms Ti/mL was prepared and measured to have a signal-to-signal ratio of 2.41 Ti: 1.00 Co.

Determine the concentration (moles/L) of titanium in the original unknown solution.

Reference no: EM13173998

Questions Cloud

What annual rate of return must the endowment fund earn? : A permanent endowment at the University of Alabama is to award scholarships to engineering students. The awards are to be made beginning 5 years after the $10 million lump-sum donation is made

Methane gas will be produced in anaerobic decomposition : How much of methane gas will be produced in anaerobic decomposition assuming a complete conversion of MSW into CH4CO2NO, and SO2.

State and assume a negligble volume change : moles of H30+ or OH- must you add to 8.92 L of HA solution to adjust its pH from 4.34 to 5.09? assume a negligble volume change

Plot the process path in a p-v diagram : Helium gas is heated at constant volume from a state of 100 kPa, 300 K to 500 K. A following process expands the gas at constant pressure to four times the initial volume.

Concentration of titanium in the original unknown solution : As a reference, a standard mixture containing 2.26 micrograms Co/mL and 1.92 micrograms Ti/mL was prepared and measured to have a signal-to-signal ratio of 2.41 Ti: 1.00 Co.

Determine the m&o costs for alternative s : Alternative S has a first cost of $175,000 and a $40,000 salvage value after 5 years, but its annual M&O costs are not known.

Calculate if the cycle were traversed in opposite direction : It is then restored to its original state by the extraction of heat at constant pressure. Calculate w for each step and for the total process. What values for w would you calculate if the cycle were traversed in the opposite direction?

Calculate the percent by mass of the caco3 in the sample : dissolving 3.00g of impure CaCO3 in excess HCl produced .656L of CO2- measured at 20C and 782mmHg. calculate the percent by mass of the CaCO3 in the sample.

State the rock sample and the associated uncertainty : Type your question hereA 0.1390-g rock sample of unknown concentration was dissolved in HCl and diluted to 100.0 mL. Aliquots of 10.00 mL of this unknown solution were added to different volumes

User Account

All Pages