Compute what is the power dissipated by the resistor

Assignment Help Electrical Engineering
Reference no: EM131216092

Assignment Introduction to Electricity Markets

Problem 1

For the circuit below, what is the total equivalent resistance between the terminals of the voltage source? Show your work.

1684_Circuit_Diagram.jpg

Problem 2

For the simple circuit shown below:

1568_Circuit_Diagram_1.jpg

a. What is the current i1? Which of Kirchhoff's Laws do you use to find this?

b. What is the current i1? Which of Kirchhoff's Laws do you use to find this?

c. Use Ohm's Law to find the voltage drop across the resistor.

d. What is the voltage v0 provided by the 1.5A current source? Which of Kirchhoff's Laws do you use to find this?

e. What is the power dissipated by the resistor?

Problem 3

A toaster oven has a resistance of 24 ohms. At a voltage of 120 V, what is the current through the toaster, and how many watts of power does it draw? How many kilowatt-hours of electric energy does this toaster oven consume in a 30-day month, if it operates for 20 minutes every day?

Problem 4

Rumor has it that some time back in the 1980s, some European utility companies were accused of trying to increase their revenue by simply raising the service voltage for unsuspecting customers by a few percent. For example, instead of supplying 220 V as expected at the customer service drop, they might have supplied 230 V instead. In general terms (using equations for voltage, current and power), explain why the utility might expect to sell more kWh of electric energy if the service voltage were raised.

Problem 5

The circuit shown in the figure below has one generator and one customer ("load"). Assume that the generator produces 100 MW of power.

a) Calculate the power flows (flow rates, actually) along each of the two transmission lines. (Note: the flows should take units of MW. Don't forget to include the units in your answer!)

1134_Circuit_Diagram_2.jpg

b) Repeat part a), but assume that the resistance of Line 1 is 2R, and the resistance of Line 2 is 3R.

Problem 6

In the three-­-node network shown in the figure below, two of the lines have resistance R and one of the lines has resistance 2R.

490_Node Network.jpg

a) Suppose that Generator 1 produces 10 MW of power, while Generator 2 produces 30 MW of power. All of the power is consumed by the load (customer) at Node 3. Calculate the flows (in MW) across all three transmission lines. You may ignore transmission losses in your calculations.

b) Repeat part a), but assume that Generator 2 produces 50 MW of power.

Reference no: EM131216092

Questions Cloud

Check whether your solution is right using dasylab : How could the system illustrated be simplified - for instance by cutting the number of modules - without changing the properties of the system. Check whether your solution is right using DASYLab.
Determine units produced at normal capacity : Using the following information, prepare a factory overhead flexible budget for Jacob Company where the total factory overhead cost is $206,500 at normal capacity (100%). Include capacity at 60%, 80%, 100%, and 120%. Total variable cost is $15.25 per..
What is the process time of the order picker : Wally is not satisfied with the number you give in (a); he wants the process capacity to become larger. There is a worker recently hired. Who do you want the new worker to help? Order taker, picker, or packer? Why?
Does it matter what gender an artist is : There were very few female Impressionist artists. - Does it matter what gender an artist is?-  Does being male or female affect the subject an artist chooses or the ways in which that subject is portrayed?
Compute what is the power dissipated by the resistor : What is the power dissipated by the resistor? What is the voltage v0 provided by the 1.5A current source? Which of Kirchhoff's Laws do you use to find this? What is the current i1? Which of Kirchhoff's Laws do you use to find this?
What is the combined effect of curvature : What is the combined effect of curvature and refraction for a 300 foot long level shot - How much (and in what way) should the preliminary elevation of the seventh turning point be adjusted (± 0.01')?
Create the illusion that each user has a dedicated machine : CS-155 Concepts of Computer Science - Which of the following tracks the progress of a program during execution and create the illusion that each user has a dedicated machine?
Taxpayer works at corporation nearing the end of fiscal year : A taxpayer works at a corporation nearing the end of its fiscal year. The company has had a very successful (profitable) year and has decided to award the employee a cash bonus of 20% of annual salary (a bonus of $30,000). Assuming she can earn 5% af..
Difference between an analog and digital signal : When is the spectrum of a periodic analog signal reproduced correctly via digital signal processing by means of FFT?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd