Compute the volume flow rate required to produce

Assignment Help Civil Engineering

Reference no: EM13548156

A large pipeline with a 1.200 meter inside diameter carries oil similar to SAE 10 at 110 degrees celcius (sg=0.8). Compute the volume flow rate required to produce a Reynolds number of 3.60 x 10 ^4. then, if the pipe is clean steel, compute several points of the velocity profile and plot the data.

Reference no: EM13548156

Questions Cloud

What percentage of the total load is carried by the shaft : What would be the load carrying capacity of a 250 mm-diameter and 15 m-long timber pile driven into soft clay with an unconfined compressive strength of 40 Kpa? What percentage of the total load is carried by the shaft?

Estimate its load carrying capacity assuming a safety factor : A 12 m-long and 800 mm-diameter drilled pier is constructed in a clayey soil with a1.5 m-diameter bell at the base. The top 7 m of the clay has an average Cu of 40 Kpa and the clay underneath has a Cu of 90 Kpa

For the problem compare two cases : A 250 mm- diameter and 16 m-long timber pile is driven into a sandy soil where ?= 18 kN/m3 and ?' = 34 degree. Estimate the maximum load allowed on the pile with a safety factor of 2.5

What is the probability that among 10 automobile accidents : Assuming that 50% of the automobile accidents are due to a speed violation. a) What is the probability that among 10 automobile accidents at least 6 will be due mainly to a speed violation?

Compute the volume flow rate required to produce : Compute the volume flow rate required to produce a Reynolds number of 3.60 x 10 ^4. then, if the pipe is clean steel, compute several points of the velocity profile and plot the data.

At what depth would the vertical effective stress in a deep : At what depth would the vertical effective stress in a deep deposit of clay be 100 kpa, if e=1.1? The ground water level is a 1 m delow ground surface and S=95% above the groundwater level. Neglect pore air pressure.

Determine the allowable soil pressure for a maximum settle : A square footing 6ft by 6ft is to be installed 6ft below ground level on a sand stratum. Standard penetration tests were conducted on the construction site

Find the flow rate if the pump puts 22 hp in to the flow : A 110 f t long, 5 in in diameter (f = 0:033) connects two reservoir whose water surface elevations differ by 12 f t. Compute flow rate in pipe.

Express the approximate alkalinity of this water as mg : A water sample has bucarbonate concentration of 220 mg/l ( HCO3- )and the PH of the water is 7.9 > Express the approximate alkalinityof this water as mg/l of CaCO3

User Account

All Pages