Compute the value of pb in atm when h=10 m and density

Assignment Help Civil Engineering

Reference no: EM13548166

A large closed tank is pressurized as shown. A jet of fluid issues from a small hole. Assume the flow is incompressible, irrotational, quasi-steady and the only body force acting is gravity. Determine the pressure, pb, required to increase the jet velocity by 50% relative to the value realized for atmospheric pressure, pa, in the upper chamber. Compute the value of pb in atm when h=10 m and density=998 kg/m^3. What is the jet velocity, U, for this pressure?

Reference no: EM13548166

Questions Cloud

Compute the required layout distance if the temperature : A distance of 72.55 ft is recorded using a steel tape weighing 0.016 lb per foot. The tapes is supported only at the ends with a tension of 15 lb. Find the distance corrected for sag.

The pipe entrance is flush and square edged : Water flows through 800 feet of 12-inch diameter iron pipe (? = 0.0018 inches) between 2 open storage tanks, whose water surface elevation difference is 16 feet. The pipe entrance is flush and square edged

Determine the force in each member : The truss shown consists of 9 members and is supported by a ball and socket at A, two short links at B, and one short link at G. Check that this truss is a simple truss, that it is completely constrained

Determine the coefficient of statics friction between : A hawser is wrapped two full times around a bollard. by exerting an 80 pound force on the free end of the hawser a dockworker can resist a force of 5000 on the other end of the hawser.

Compute the value of pb in atm when h=10 m and density : A large closed tank is pressurized as shown. A jet of fluid issues from a small hole. Assume the flow is incompressible, irrotational, quasi-steady and the only body force acting is gravity.

Will there be any difference between the discharge velocitie : If a hose whose discharge end is left open on the ground is first connected to the lower valve and then to the higher valve, will there be any difference between the discharge rates of water for the 2 cases? Neglect frictional effects.

A fan is to be selected to ventilate a bathroom whose : A fan is to be selected to ventilate a bathroom whose dimensions are 2 m x 3 m x 3 m. The air velocity is not to exceed 8 m/s to minimize vibration and noise.

Determine the acceleration of the rod : A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out?.

Will the surveyor have to measure to locate the new station : Station 3 + 54.67 must be marked in the field. if the steel tape to be used is only 99.98 under standard conditions and if the temperature is 87 degree farenheit at the time of the measurement, how far away from the existing station mark at 0 + 79.23..

User Account

All Pages