Compute the value of l-q of the circuit and the bandwidth

Assignment Help Electrical Engineering
Reference no: EM13294673

A series RLC circuit resonates at 1000 rad/sec. If C =20uF, and it is known that the impedence at resonance is 2.4 ohms,compute the value of L, the Q of the circuit, and the bandwitdh.

Reference no: EM13294673

Questions Cloud

Determine the resonant frequency-q and bandwitdh : A variable-frequency voltage source of value 12cos(wt) drives a network with a resistor of value 12 ohms, an inductor of value 50mH, and a capacitor of value 5uF, all in series, in that order.
Assuming that interest rates and expectations about the : What is the spot exchange rate, E$/CD? Assuming that interest rates and expectations about the future exchange rate remain unchanged, will the spot exchange rate change over time?
For which fuel is this a more appropriate gauge : A simple fuel level gauge can use the dielectric constant of the fuel to indicate its level in a tank. For which fuel is this a more appropriate gauge
Define the organic compound di-n-butyl phthalate : The organic compound di-n-butyl phthalate, C16H22O4(l), is sometimes used as a low-density (1.046 g·mL-1) manometer fluid. Compute the pressure (in torr) of a gas that supports a 507-mm column of di-n-butyl phthalate
Compute the value of l-q of the circuit and the bandwidth : A series RLC circuit resonates at 1000 rad/sec. If C =20uF, and it is known that the impedence at resonance is 2.4 ohms,compute the value of L, the Q of the circuit, and the bandwitdh.
Calculate the maximum speed of the mass : A 2.0 kg mass is attached to the end of horizontal spring (k = 50 N/m), What is the maximum speed of the mass
What interest rate is the bank required to report : First Century Bank wants to earn an effective annual return on its consumer loans of 10 percent per year. The bank uses daily compounding on its loans. By law, what interest rate is the bank required to report to potential borrowers?
What charge was originally stored : A parallel plate capacitor is constructed with Teflon (dielectric constant 2.1) between the plates. What charge was originally stored
What happens to the acceleration : A student is doing Lab 3: Motion in One Dimension. The student places 50 g on the cart and 50 g one the hanger, What happens to the acceleration

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How much more efficient in terms of miles per kwh is tesla

The fuel tank contains 33 kWh per gallon. If the vehicle were to be replaced by an electric vehicle that charges from the power grid, how much power would it draw (in W, kW, or MW) to recharge at the same rate as the gasoline powered automobile

  Find input current and power factor at maximum torque

A 500 hp, three-phase, 2200 V, 60 HZ, 12-pole, Y-connected, wound-rotor induction motor has the following parameters: R1 = .225 ohm : R'2= .235 ohm Xeq = 1.43 ohm and Xm = 31.8 ohm and Rm = 780 ohm

  What is the rms value of the current through the capacitor

a 10uF capacitor is plugged into a 110v rms 60 hz voltage source with an ammeter in series. what is the rms value of the current through the capacitor?

  Derive equations for the electric flux density for all ?

Given a coaxial cable with solid inner conductor of radius a, an outer conductor that goes from radius b to c (so c>b>a), a charge +Q that is assumed evenly distributed throughout a meter length of the inner conductor

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Design a digital controller that has a bandwidth of 100 hz

The read arm of a computer disk drive has the transfer function of G(s) = 1000/s^2. Design a digital controller that has a bandwidth of 100 Hz and a phase margin of 50 degrees. Use a sample rate of 6kHz.

  Specify requirements on adc and appropriate analog signals

A calibrated RTD a = 0.0041/°C, R=306.5-ohm at 20°C, and PD= 30mW/ °C will be used to measure a critical reaction temperature. Temperature must be measured between 50 °C and 100 °C with a resolution of at least 0.1°C.

  Write a program to genrate a square wave

assuming XTAL=11.0592 MHz,write a program to genrate a square wave of 20 Hz frequency on pin2.3?

  Determine what value is required for the second resistor

A voltage divider is required to produce a 5.5 v output from a 12 v source. If one of the resistor values is 1.0 k, what value is required for the second resistor so that the voltage across the 1.0k resistor is 5.5v

  If the string is vibrating in fifth harmonic how long is it

The wave function of a certain standing wave on a string fixed at both ends is y(x,t) = 0.30 sin(0.0025x)cos(300t) where y and x are in centimetres and t is in seconds. If the string is vibrating in its fifth harmonic, how long is it

  What signal strength should satellite receiver by processing

A satellite is 30,000 km from the Earths surface, receives signals at 14 GHz transmitted from the earth with an average power of 50 W, with an antenna gain of 55 dB in the direction of the satellite receiving antenna.

  Determine the value of r and the total power delivered

An unspecified resistance, R, and a 12Ω resistor are both connected across a 24V source in parallel. The power dissipated by R is 12W. Determine the value of R and the total power delivered by the source.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd