Compute the tension in the rope

Assignment Help Physics
Reference no: EM13712381

Problem: A small object with mass 0.200 kg swings back and forth on the lower end of a light rope that is 3.00 m long. The upper end of the rope is attached to the ceiling. As the object swings through its lowest position, where the rope is vertical, the speed of the object is 8.30 m/s.

Part A: At this point in the motion, what is the tension in the rope? (Use g = 9.80 m/s2).

Please provide all work and steps to determine the tension in the rope.

Reference no: EM13712381

Questions Cloud

Greening new and emerging markets : Greening new and emerging markets: Defining Best Practices Due 5/8. A. Pick an existing market that's small enough to shift with localized effort ( Portland Oregon Breweries/ Beer Industry/ Sustainability).
Find what the magnitude of the initial velocity : A projectile is launched at an angle of 34.9 degrees above the horizontal and lands at the same level from which it was launched 2.07 seconds later. Find the magnitude of the initial velocity
Made of plastic with a maximum working stress : A camera case shown on the right is made of plastic with a maximum working stress of 1000 psi. What thickness of material should be used to create the case if the case will be used at 150 feet of depth in sea water?
Determine the change in specific kinetic energy : Steam steadily flows through a turbine to produce mechanical work. At the inlet, the pressure, temperature and velocity of the steam are 10 MPa, 450 °C and 110 m/s, respectively. The water exits this turbine at pressure of 10 kPa with the quality of ..
Compute the tension in the rope : A small object with mass 0.200 kg swings back and forth on the lower end of a light rope that is 3.00 m long. what is the tension in the rope
Consider two people playing an ultimatum game : 5) Consider two people playing an ultimatum game over $10 that can be divided in $1increments ($10-$0, $9-$1, $8-$2, etc.). Suppose it is common knowledge among them that both have Fehr-Schmidt utility functions with the assumptions given i..
Estimate what the magnitude of the net magnetic field : The current in a solenoid with 50 turns per centimeter is 0.44 A. The solenoid has a radius of 1.5 cm. Find the magnitude of the net magnetic field
Hydrostatic tension-hydrostatic compression : What would happen to safety of factor of brittle material under the state of Hydrostatic tension, Hydrostatic compression
What is the x-component of the electric field at the point : A -70nC charge is distributed uniformly along the x-axis from x = -0.8m to x = 2.6m. Consider a point at y = 1.5m on the y-axis. What is the x-component of the electric field at the point

Reviews

Write a Review

Physics Questions & Answers

  What is the half-life of the state

If the uncertainty in the energy of an excited state is a billionth of an electron volt (1 neV), what is the half-life of the state

  How much heat must be added to the air in the balloon

On a sunny morning in a ?eld, the atmospheric pressure is 10N/m and the temperature is 279 K. How much heat must be added to the air in the balloon to initiate the ?ight

  How many turns must there be in the output coil

The generator at a power plant produces AC at 23,000 V. A transformer steps this up to 335,000 V for transmission over power lines. how many turns must there be in the output coil

  Magnitude of the maximum force of static friction is equal

In a popular amusement park ride, a rotating cylinder of radius R = 3.10 m is set in rotation at an angular speed of 4.20 rad/s, as in the figure shown below. The floor then drops away, leaving the riders suspended against the wall in a vertical posi..

  What is the spheres linear displacement

A spherical mass on a rod of length L rotates rigidly about a fixed axis at the opposite end of the rod. What is the sphere's linear displacement

  Determine the minimum nonzero thickness

A nonreflective coating (n = 1.31) covers the glass (n = 1.52) of a camera lens. determine the minimum nonzero thickness that the coating can have

  Illustrate what is coefficient of kinetic friction of skis

The skis have a thrust of 220 . Sam's speed at the bottom is 45.0. Illustrate what is the coefficient of kinetic friction of his skis on snow?

  Evaluate the magnitude of the magnetic field inside toroid

A toroid having a square cross section, 3.00 cm on a side, and an inner radius of11.0 cm has 500 turns and carries a current of 0.800 A. evaluate the magnitude of the magnetic field insidethe toroid

  Q1an underwater diver sees the sun 50 degrees above

q1.an underwater diver sees the sun 50 degrees above horizontal. how high is the sun above the horizon to a fisherman

  Determine the refractive power of the glasses

People who suffer from cataracts may have the lenses in their eyes replaced by artificial lenses. what is the refractive power of the glasses she will need to see the object clearly

  What is the potential difference across the capacitor

A 3.4-cm-diameter parallel-plate capacitor has a 1.8mm spacing. The electric field strength inside the capacitor is 1.3×105V/m, What is the potential difference across the capacitor

  Calculate the force that can be resisted by a piston

If a 200 N force F1 is applied to the piston with the 4 cm diameter, Calculate the magnitude of the force F2 that can be resisted by the piston with the 10 cm diameter? Ignore the weights of the pistons.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd