Compute the probable settlement of the building

Reference no: EM13535610

The construction of a multi storied building started in January 1989 & was completed in June 1990. The total consolidation settlement of the building was estimated to be 8 cm. The average settlement of the building was measured in December 1991 & was found to be 2.2 cm. Compute the probable settlement of the building in January 2001.

Please provide reasons in every steps.

Reference no: EM13535610

Questions Cloud

Identify the contaminants on site and explain : Identify the contaminants on site and explain their hazards in relation to the proposed design and its construction. Describe the ‘In-situ’ and Ex-situ’ treatments that could be used and their relative merits

Briefly outline with the use of neat labelled sketches : It is proposed to make a new pedestrian access running directly south from University Square to Silvertown. The physical barriers that need to be overcome are the Royal Docks and the City Airport runway.

Determine the pressure between the sleeve and cylinder when : Maximum shear stress both in the tube and sleeve is 16000 psi. Calculate the fluid pressure, and determine the pressure between the sleeve and cylinder when the fluid pressure is absent.

What is normally consolidated clay : Compute the nominal shear strength of an M10 x 7.5 of A 572 grade 65 steel

Compute the probable settlement of the building : The construction of a multi storied building started in January 1989 & was completed in June 1990. The total consolidation settlement of the building was estimated to be 8 cm.

Determine the quantify the losses in this system : At Point A, in a pipeline carrying water (γ=62.4 lb/ft^3) the diameter is 4.0 ft, the pressure is 10 psi, and the velocity 4 ft/s. At point B, 6ft higher than point A, the diameter is 2 ft and the pressure is 2ps

What is the average crack spacing for that reinforcement : Compute the effective composite modulus of subgrade reaction (please consider the subbase, the presence of a relatively shallow rock foundation, and the potential loss of support)

Develop a preliminary design, including flow rates : Develop a preliminary design, including flow rates, pipe sizes, and pipe slopes for a trunk sewer to be laid in the development shown in the accompanying figure from 6th to 1st Streets along Peavy Avenue.

Compute the atomic packing factor for cesium chloride : Compute the atomic packing factor for cesium chloride assuming thatthe ions touch along the cube diagonals. Ionic radii ofCs+ and Cl- are 0.170 nm and 0.181 nm,respectively

User Account

All Pages