Compute the pressure at a point in a building

Assignment Help Civil Engineering
Reference no: EM13534550

1.If water is moving at a constant rate through a level conduit andthe pressure is measured as 100 psi at P1 and 90 psi atP2, what is the head loss ( in feet) due to friction?There are no external forces acting on the water. Temperature is60oF

2.The water in a tank is 35 feet deep. Temperature=70oF. What is the gage pressure in psi at the bottom ofthe tank?

3.Calculate the amount of water that will impact a five acre field from 5 inches of rainfall. Express the answer in gallons and cubic meters.

4. A rectangular culvert 4 feet x 6 feet is running full and discharging 3,500 cfm. There is no friction loss. Find the velocity in fps. The culvert empties into a 10 ft wide culvert and the velocity reduces to 0.6 fps. How deep is the water level in the second culvert?

5.Compute the height (h) of the water tank above theground surface to provide a static pressure of 75 psi.

Compute the pressure at a point in a building that is 40 feet abovethe ground surface.

Note: the pressure in a water system will range from 40- 90psi. Compute the range in h corresponding to this range inpressure. Answer in feet

Reference no: EM13534550

Questions Cloud

What is the conversion rate for parts per million by volume : What is the conversion rate for parts per million by volume (ppmv)conversion. How is this converted into atm, Pa, and torr?
Calculate specific surface : Immediately after the bouncing golf ball leaves the floor itscomponent of velocity are Vx= 0.662 m/s and Vy= 3.66 m/s. determinethe horizontal distance from the point where the bal
Is the fluid accelerating uphill : A fluid with a specific weight of 100lb/ft^3 and a negligibleviscous effects flows in a pipe. The pipe is inclined at 30degrees. Point (1) is located above point (2) in the pipe.
Show that 1 millimeter of the 0.02 n h2so4 solution : A load of 14 tonnes is suspended at the end of a steel rope.If the load is subjected to a maximum acceleration/deceleration of2.5m/s2, when raised and lowered, calculate the diameter of therope needed to support the load. Assume the following:
Compute the pressure at a point in a building : A rectangular culvert 4 feet x 6 feet is running full and discharging 3,500 cfm. There is no friction loss. Find the velocity in fps. The culvert empties into a 10 ft wide culvert and the velocity reduces to 0.6 fps. How deep is the water level in th..
What is the meaning of most efficient crosssection : A rectangular channel has a bottomwidth = b and flow depth = y. Prove that for a given area, the mostefficient rectangular cross section is one with y = b/2.
What is the concentration in ppm at the downstream reach : Five million gallons per day (mgd) of a conservative substance,with concentration of 10 mg/L is released into a stream having anupstream flow of 10.0 mgd and a substance concentration of 3 mg/L.Assume complete mixing.
What is the true air speed : Given that an aircraft flying at FL350 encounters a tailwindof 35 knots and the instrument in the cockpit shows anindicated airspeed of 310 knots. What is the standard atmosphere atthis altitude?
What is the area of one of these walls : A new athletics stadium with a curved concrete roof is beingdesigned. Each of the end walls is 25 metres long. Its height ymetres is given by

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the overall efficiency of the system

A gas stream with a particulate loading of 20.0g/m^3 is passed through a 70%-efficient cyclone followed by a 95%-efficient ESP. Calculate the overall efficiency of the system.

  Determine the mass and stiffness of the undamped system

The mass m, stiffness k, and natural frequency fn of an undamped SDF system are unknown. These properties are to be determined by harmonic excitation tests. at an excitation frequency of 4 Hz, the response tends to increase without bound.

  Determine the tensions in the cables and the reactions

The suspended load exerts a force F = 600 lb at A and bar OA weighs 200 lb. Assume that the bar's weight acts at its midpoint. Determine the tensions in the cables and the reactions at the ball and socket support O.

  Determine what is local acceleration along the centerline

velocity of water in the nozzle is given by V=2t/(1-.5x/L)^2. L = 4ft. When x=.5L and t=3s what is the local acceleration along the centerline. What is the convective acceleration.

  What is the rate of energy in kw that enters into the air

A 40 oF breeze of 10 miles per hour blows over the top of a round open-top water cooling tank which has a bulk temperature of 100 oF. What is the rate of energy in kW that enters into the air

  Find the resulting stress in the steel pipe material

A steel pipe carries an industrial oil under pressure. The steel pipe inside diameter is 36 in, the pressure head on the fluid is 383.0 ft. A)- Find the internal fluid pressure in psi

  Determine required diameter of each rod by the concrete

The column is constructed from high-strength concrete and four A-36 steel reinforcing rods. If it is subjected to an axial force of 37.5 kN , determine the required diameter of each rod so that one-fourth of the load is carried by the concrete

  Find the horsepower delivered to the water by the pump

It leaves the pump through a 4-in-diamter pipe at 15 psi. Assuming that the suction and discharge sides of the pump are at the same elevation, find the horsepower delivered to the water by the pump.

  The existing flash mixer is about 20 years old and needs to

an existing water treatment plant is producing an average flow of 0.5 mgd. due to several limitations the plant only

  1 an analysis of dredged sediments from a stormwater

1. an analysis of dredged sediments from a stormwater retention basin revealed a high concentration in mgkg of the

  Determine the force in the rod for the temperature

The rod is made of a-36 steel and has a diameter of .25 in. if the springs are compressed 0.5 in when the temperature of the rod is T=40F, determine the force in the rod when its temperature is T=160 F.

  Calculate the co-efficient of permability of the soil

In a falling-head permeability test the initial head of 1.5m dropped to 0.5m in 4 h the diameter of the standpipe being 5mm. The soil specimen was 200mm long by 100mm in diameter.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd