Compute the point load strength anisotropy index

Assignment Help Civil Engineering
Reference no: EM13501498

1- In a 1500-mm rock core run, the following rock pieces were recovered from a borehole:

55mm, 108mm, 76mm, 102mm, 132mm, 276mm, 95mm, 168mm, 21mm, 63mm. find the RQD and the core recovery ratio.

2- Point load tests were carried out on two sedimentary rock speci¬mens of 54 mm diameter (NX core), as shown the following figure The loads P1 and PII at failure are 6.28 kN and 4.71 kN, respectively. Find the point load strength index Ism) in the two directions and compute the point load strength anisotropy index 1,(s0)

363_Find the point load strength index.png

Reference no: EM13501498

Questions Cloud

What is the maximum safe pressure for the can : An aerosol can is pressured at 440kPa when it's refrigerated at 3 degree Celsius. What is the maximum safe pressure for the can
Determine the time difference between the two flashes : You are standing at = 9.0 km Lightning bolt 1 at x= 0km and lightning bolt 2 at x = 12.0km. what is the time difference between the two flashes
Explain why a geothermal system is initially more expensive : A geothermal system is initially more expensive to set up than a conventional heating and cooling system but the annual operating cost are much cheaper
How much work does gravity do on the book : A 1.8 book is lying on a 0.70 -high table. You pick it up and place it on a bookshelf 2.3 above the floor. How much work does gravity do on the book
Compute the point load strength anisotropy index : Find the point load strength index in the two directions and compute the point load strength anisotropy index 1,(s0)
What is the balls speed relative to the ground : A boy on a skateboard coasts along at 6.0 m/s. He has a ball that he can throw at a speed of 10 m/s. What is the ball's speed relative to the ground if he throws the ball forward
Explain the concentration of the solution in units : Lactose, C12H22O11, is a naturally occurring sugar found in mammalian milk. A 0.335 M solution of lactose in water has a density of 1.0432 g/mL at 20 degrees Celsius. What is the concentration of this solution in the following units
What was the speed of the clay immediately before impact : A 13.0-g wad of sticky clay is hurled horizontally at a 90-g wooden block initially at rest on a horizontal surface. The clay sticks to the block. what was the speed of the clay immediately before impact
Prepare absorption costing income statements : If the company wishes to earn an after-tax income of $3,000,000, what is the break even in units?  Assume that the corporate income tax rate is 40%.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Volume of the lake

Suppose that the distance from the lake outlet to the withdrawal cannot be more than 20 mi. What should be the new volume of the lake?

  Determine what would be the flow rate in gpm

Suppose that a water treatment plant has a Parshall Flume with a 4 ft wide throat. a) If the upstream depth of the water (ha) is 1 ft and the depth of the water in the throat section (hb) is 0.65 ft, what is the flow rate in gpm

  Determine the volume flow rate of the water

A horizontal water jet impinges against a vertical flat plate at 25 ft/s and splashes off the sides in the vertical plane. If a horizontal force of 350 lbf is required to hold the plate against the water stream,

  Sufficient collapse strength

Would a 30 slot stainless steel screen (2.0 m long; located at the bottom of the well) have sufficient collapse strength for this application?

  How much error would there be in the volume calculation

Assume the actual water temperature for calibrating a 1/3 ft3 measure was 65 degrees F. If you had used a water temperature of 75 degrees F for your calibration, how much error would there be in your volume calculation (both in ft3 and as a percen..

  1 draw a plan of a typical strip mine showing all

1. draw a plan of a typical strip mine showing all operational features and equipment.2. answer the followinga. why is

  What is the amplitude of the vertical vibration

if the enginer is mounted floatiing on very weak spring, what is the amplitude of the vertical vibration of the engine? (b) if the engine is mounted solidly on a rigid foundation, what is the alternating force amplitude transmitted? Assume the con..

  Determine how will the flow divide into pipeline branches

A 24-inch pipeline branches into a 12-inch and an 18-inch pipe, each of which is 1 mile long, and they re-join back into a 24-inch pipe. If the flow rate is 30 CFS in the main pipe

  Determine how to convey 2 cfs through the system

A pump of 80% efficiency lifts water from one large open tank to another; the difference in water surface elevations is 20 feet. The pipe is relatively smooth (f = 0.0122), and has 3 elbows, each with a loss coefficient of 2/3.

  How many of the incinerators in chicago meet the standard

Stack gas samples were collected from a sample of 50 incinerators in Chicago. Of the 50 samples, only 18 met an environmental standard for the concentration of a hazardous compound. Can it be concluded that fewer than half of the incinerators in C..

  Determine what is the angular rotation rate of the car

A car is travleing towars a 20 degree slope at 60 mph. The wheels have a radius of 12 in. and the car's wheelbase is 100 in. What is the angular rotation rate of the car immediately after the front wheel contacts the slop

  What is the angular rotation rate after front wheel contacts

A car is traveling toward a 20 degree slope at 60 mph. The wheels have a radius of 12 in, and the car's wheelbase is 100 in. What is the angular rotation rate of the car immediately after the front wheel contacts the slope

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd