Compute the natural frequency

Assignment Help Mechanical Engineering

Reference no: EM13711479

Consider a model of a building whose base moves as a result of an earthquake. The building can be modeled as a single-degree-of-freedom spring-mass system where the building mass is lumped on top of two beams used to model the walls of the building. The ground motion has amplitude of 0.1 m and a frequency of 7.5 rad/s. The building mass is 105 kg and the stiffness in bending of each wall is 3.519*10^6N/m.

a) Write down the equation of motion of the mass, which represents the building.

b) Compute the natural frequency

c) Compute the amplitude X of the steady-state response.

d) Does the amplitude seem large? Comment on your answer.

e) What is the amplitude of the force transmitted to the building?

Reference no: EM13711479

Questions Cloud

Changes in kinetic and potential energies is zero : Ten cubic feet of air is cooled at a constant pressure of 80 psi. The initial temperature is 180 0F and the final temperature is 100 0F. Assume air is an ideal gas, Cp = 0.241 Btu/lb 0R and Cv = 0.173 Btu/lb 0R and R = 1545 lbf/lbmol 0R, M = 28.97 lb..

Solid glass-polymer reinforced composite rod : Solid glass-polymer reinforced composite rod (diameter = 100 mm) is simultaneously torqued clockwise (T = 1,000 Nm) and given a tensile load (P = 0). Determine shear strain. Determine extensional strains in n and t directions.

Calculate the maximum shear stress for each stress element : A cantilever beam with a 1 in diameter is loaded at the tip with a transverse force of 1000 lb. Figure 2.1 below shows the beam configuration and cross-section with points A at the top, point B at the center and point C at the midpoint between A and ..

Heat exchanger tubes have to be shorter txceed : In a Modified Rankine Cycle used in a power plant in Wichita, KS, a Shell and Heat Exchanger needs to be installed. Water from the turbine at 90 C is cooled to 80 C in a shell-tube HX using 150 kg/s of raw water from Power Plant Lake.

Compute the natural frequency : Consider a model of a building whose base moves as a result of an earthquake. The building can be modeled as a single-degree-of-freedom spring-mass system where the building mass is lumped on top of two beams used to model the walls of the building. ..

What is the resulting strain of the wire when it is used : Company wants to use a 100 m long steel cable to pull an airplane glider. If the glider has a mass of 1000 kg, and assuming the load is given by F=mg = 9800 N, and if the Young’s modulus of steel is 200 GPa (200,000,000,000 Pa), and Poisson’s ratio i..

Determine the stress and slenderness ratio : A 10 inch long cantilevered beam has a 1” by 1” square cross section. The load at the end of the beam cycles from 0 lbs to 300 lbs. determine the stress. Determine the slenderness ratio and column constant of a 38” long steel column that has a 1.5 in..

Piston-cylinder assembly in an air atmosphere : A piston-cylinder assembly in an air atmosphere of p = 1 atm (= 1.013 bar) contains 1 kg of nitrogen. The initial volume of the nitrogen is 1 m^3, and its initial pressure is 1 atm. The side of the cylinder is heated such that the heat transfer to th..

Slowly reduce the frequency to the point of synchronisation : Why do you think it is important, when using a stroboscope, to start at a very high frequency and slowly reduce the frequency to the point of synchronisation?

User Account

All Pages