Compute the ionization of the aspirin

Assignment Help Chemistry

Reference no: EM13212880

When dissolved in your stomach (pH=1) the concentration of aspirin (acetylsalicylic acid Ka = 3.0 x 10 ^-4) is 0.2 M. Calculate the % ionization of the aspirin.

A) 0.3%
B) 3.0%
C) 50%
D) 100%
E) Cannot be determined with the given information

Reference no: EM13212880

Questions Cloud

Determine the torque that can be applied to a solid : assuming that the solid shaft has been replaced by a hollow shaft of the same cross-sectional area and with an inner diameter equal to half of its own outer diameter.

State how many moles of oxygen are in a compressed cylinder : How many moles of oxygen are in a compressed cylinder that has a volume of 8.00 L at a pressure of 41.0 atm and at 25 degrees celcius?

Determine temperature at which the water starts boiling : A cooking pot whose inner diameter is 20 cm is filled with water and covered with a 4-kg lid. If the local atmospheric pressure is 101 kPa, determine the temperature at which the water starts boiling when it is heated.

How does tension spread over the line abad : A small boat hangs from two davits, one of which is shown in the figure. The tension in line ABAD is 82 lb, determine the moment about C of the resultant force exerted on the Davit.

Compute the ionization of the aspirin : When dissolved in your stomach (pH=1) the concentration of aspirin (acetylsalicylic acid Ka = 3.0 x 10 ^-4) is 0.2 M. Calculate the % ionization of the aspirin.

What is the price the firm will set as a monopolist : Given the following information, model the following monopoly for a strain of corn which has been patented in a totally, not-at-all-evil way by multinational agri-corp Notmonsanto. (HINT: Set up a table with Quantity in increments of 0.5)

What value of sp is required : In a tubular low pressure chemical vapor deposition (LPCVD) reactor, gas is introduced at one end at a rate of 75 torr-L/min. At the other end is a vacuum pump of a speed Sp. If the reactor must operate at 1 torr, what value of Sp is required?

What is the actual mechanical advantage of the system : what is the actual mechanical advantage of the system?

Determine the velocity of each block : Block A has a mass of 3 kg and B has a mass of 5 kg. If the system is released from rest, determine the velocity of each block in t=4s. Neglect the mass of the pulleys.

User Account

All Pages