Compute the heat transfer-methane flows with the velocity

Assignment Help Mechanical Engineering

Reference no: EM13706011

At a section where the diameter is 4 in, methane flows with the velocity of 50ft/s and a pressure of 85 psia. At a downstream section, where the diameter has increased to 6 in, the pressure is 45 psia. Assuming the flow to be isothermal, compute the heat transfer between the two locations

Reference no: EM13706011

Questions Cloud

Heat engine operates between two temperature limits : A heat engine operates between two temperature limits of 1200 K and 300 K. It receives 1 MJ of heat while producing 450 kJ of useful work.

Determine the reversible power input : A refrigerator is maintained at 5°C by removing heat from the refrigerated space at 18,000 kJ/hr. The power input to the refrigerator is 1500 W and the surrounding air is at 36° C.

Determine rate of heat loss from pipe by natural convection : A 7.1cm external diameter, 6m long hot water pipe at 85 C is losing heat to the surrounding air at 15 C by natural convection with a heat transfer coefficient of 40 W/m2 C. Determine the rate of heat loss from the pipe by natural convection in Kw.

What is the velocity of the fluid in the small section : Fluid is flowing in the pipe has two areas. The velocity of the fluid flowing in the larger area is 4 ft/s. The radius of the larger area is 4 inches. The radius of the smaller section is 2 inches. What is the velocity of the fluid in the small secti..

Compute the heat transfer-methane flows with the velocity : At a section where the diameter is 4 in, methane flows with the velocity of 50ft/s and a pressure of 85 psia. At a downstream section, where the diameter has increased to 6 in, the pressure is 45 psia. Assuming the flow to be isothermal, compute the ..

Assuming that the coefficient of friction in cutting : Assuming that the coefficient of friction in cutting is 0.25 for turning a hard aluminium alloy on a 20 hp lathe (mechanical efficiency = 90%) with a width of cut of 0.24 in, a rake angle of 11°, and a cutting speed of 333 ft/min. Assume the cut is a..

Transport theorem is required in context of aircraft dynamic : Using the transport theorem approach, derive the conservation of linear momentum equations. State all assumptions. Why the transport theorem is required in the context of aircraft dynamics?

What is its spring constant : A 10kg block sliding along a frictionless surface with a velocity of 10m/s comes into contact with a horizontal, uncompressed linear spring. If the spring slows the block down to 0 m/s while being compressed a total of 30 cm, what is its spring const..

Gear is put in neutral on level road without wind resistance : The rolling resistance of a 1200kg car depends on its weigh as F = 0.006m x gravity. How far will the car roll if at 90km/h the gear is put in neutral on a level road without wind resistance?

User Account

All Pages