Compute the heat transfer between the two locations

Assignment Help Mechanical Engineering

Reference no: EM13705993

At a section where the diameter is 4 in, methane flows with the veloctiy of 50ft/s and a pressure of 85 psia. At a downstream section, where the diameter has increased to 6 in, the pressure is 45 psia. Assuming the flow to be isothermal, compute the heat transfer between the two locations

Reference no: EM13705993

Questions Cloud

Determine the work required to compress a spring : The force F required to compress a spring a distance x is given by F - Fo = kx where k is the spring constant and Fo is the preload. Determine the work required to compress a spring, whose spring constant is k = 37 kN/m, a distance of 2 cm starting f..

Determine the magnitude and location of the resiltant force : Freshwater is impounded to a height of 11 ft behind a dam as shown. Determine the magnitude and location of the resiltant force on the 4-ft by 4-ft gate.

Plate is supported by the spring and the rubber pad : The following suspension system has two support structures-a spring and a rubber pad. Vertical force F (N) acts on the moveable plate. The spring has a spring constant of k1 = 1000 N/m. The rubber pad has a spring constant of k2 = 20000 N/m. The rubb..

What size reactor is needed for operation at same temperatur : You need to hydrolyze 500 lb/day of an ester at an initial concentration of 5 molar in basic, aqueous solution. The ester has a MW of 120. The product must be 99% hydrolyzed. In bench top experiments at 40C, it is found that 50% of the ester hydrolyz..

Compute the heat transfer between the two locations : At a section where the diameter is 4 in, methane flows with the veloctiy of 50ft/s and a pressure of 85 psia. At a downstream section, where the diameter has increased to 6 in, the pressure is 45 psia. Assuming the flow to be isothermal, compute the ..

Determine the resultant of load system : Determine the resultant of load system shown below. Locate where the resultant intersects grade with respect to point A at the base of the structure

The mole fraction of ethanol in the boil up stream : A distillation column, as shown in the figure to the right, is a device used to separate components with different volatilities. In a specific process, a distillation column is used to separate a feed stream containing 0.4500 mol ethanol/mol and 0.55..

Paddle wheel and an electric heater operate in a system : A paddle wheel and an electric heater operate in a system. If the torque is 200 N-m, the rotational speed is 400 rpm, the voltage is 20 V, and the amperage is 10 A, What is the rate of doing work?

Determine the critical load : A steel column has a length of 9 m and it fixed at both ends. If the cross-section area has the dimensions shown determine the critical load. Est = 200 GPa QY = 250 MPa

User Account

All Pages