Compute the critical load when the bar is subjected to an

Assignment Help Civil Engineering

Reference no: EM13546857

1.A rectangular steel bar has cross-sectional dimensions of 12mm by 25mm and is 210 mm long. Assuming that the bar has pinned ends and is made from AISI 1141 OQT 1300 steel, compute the critical load when the bar is subjected to an axial compressive load.

2.A biodegradable wastewater is to be treated in a CMFR. The BOD5 reaction(removal) rate coefficient is 0.15/day. The CMFT has a 4000 gallon volume. What wastewater flowrate can be treated in this CMFR in order to remove 98% of the BOD5? What Volume of CMFR would be required to remove 92% of the BOD5 at the calculated flowrate?

Reference no: EM13546857

Questions Cloud

What is the illumination on the note pad : A supervisor is sitting at her desk illuminated by a 180 candela source 3 feet above it. She is writing with green ink (reflectance=30%) on a yellow note pad (reflectance=60%). What is the illumination on the note pad?

What is the step by step when design a reinforce concrete : What is the step by step when design a reinforce concrete (t-beam and rectangular beam), slab doubly reinforce?

Determine the stresses in the cables and the deflections : The steel beam ABCD shown is simply supported at A (pin) and supported at B and D by steel cables each having a diameter of 12mm. A force of 20 kN is applied at point C. For steel, let E = 209 GPa.

Compute the allowable load on a column with fixed ends : Compute the allowable load on a column with fixed ends if it is 5.45 meters long and made from an S150 x 18.6(S6 x 12.5) beam. The material is ASTM A36 steel. Use the AISC formula.

Compute the critical load when the bar is subjected to an : A rectangular steel bar has cross-sectional dimensions of 12mm by 25mm and is 210 mm long. Assuming that the bar has pinned ends and is made from AISI 1141 OQT 1300 steel, compute the critical load when the bar is subjected to an axial compressive lo..

Need to select a hydraulic pump size and a hydraulic : An Engineer is designing a hydraulic lift with a capacity of 10 tons. The moving parts of this lift weigh 1000 lbf. The lift should raise the load to a height of 6 ft in 20 sec.

Draw the influence line for the shear in panel cd : Draw the influence line for the shear in panel CD of the girder. Determine the maximum negative live shear in panel CD due to a uniform live load of 500 lb/ft action on the top beams.

What type of volcano is olympus mons : A-Olympus Mons, a 69,000-foot-tall mountain on Mars, is the largest volcano in the solar system. Its circumference at the base is large enough to cover almost the entire state of Colorado. A space probe could safely land at almost any point on the vo..

What is the approximate present worth of the 120 mm pipe : The company will use an annual interest rate of 10%. Annual maintenance and pumping costs may be considered to be paid in their entireties at the end of the years in which their costs are incurred.

User Account

All Pages