Compute the amount by which the length of stack decreases

Reference no: EM13495046

A copper cylinder and a brass cylinder are stacked end to end, as in the drawing. Each cylinder has a radius of 0.29 cm. A compressive force of F = 6250 N is applied to the right end of the brass cylinder. Find the amount by which the length of the stack decreases.

Reference no: EM13495046

Questions Cloud

Operational feasibility : Operational feasibility

Calculate the instantaneous angular acceleration : The non-constant angular acceleration of a wheel is given by a(t)=At. A=6 radians/s^3. calculate the instantaneous angular acceleration at t=1.50 seconds

Explain what mass of ar gas is contained : What mass of Ar gas (in g) is contained in a 6.40 L tank in which its pressure is 0.703 atm and the temperature is 64.0°C? Do not enter units.

Obtain the charge on the capacitor : An air-filled (suppose k=1) parallel-plate capacitor has plates of area 2.30 cm2 separated by 1.50 mm. What is the charge on the capacitor

Compute the amount by which the length of stack decreases : A copper cylinder and a brass cylinder are stacked end to end, as in the drawing. Find the amount by which the length of the stack decreases

Explain what is the freezing point of a solution : what is the freezing point (in degrees celcius) of a solution prepared by dissolving 11.3 g of Ca(NO3)2 in 115g of water. the molar mass of Ca(NO3)2 is 164g/mol

The typical developing country to improve its per capita gni : Do outside interventions provide substantial capital, enabling the typical developing country to improve its per capita GNI? Why or why not?

How can abc be used to improve profitability : Explain why Activity Based Costing (ABC) often reveals existing product cost cross-subsidization problems. How can ABC be used to improve profitability? Discuss some of the limitations of ABC.

Explain suitable safety management system to control : Compare HASAW Act with Occupational health and safety regulations of Sultanate of Oman. and give an outline of what would be needed to set up a suitable safety management system to control the hazards in a chemical process industry

User Account

All Pages