Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A tracer dye is injected into a 55-ft thick sandy gravel confined aquifer which has a hydraulic conductivity of 1.2 x 10^-3 ft/s. The dye appears 14 days later in an observation well 75 ft away from the injection point. Compute the seepage velocity and estimate the hydraulic gradient in the aquifer if the porosity of the soil is 42%.
The owner of a dive shop wants to purchase a constant displacement air compressor capable of simultaneously filling 10 SCUBA tanks. each having a volume of 0.4 ft^3. in 20 minutes.
The flat circular disk rotates about a vertical axis through O with a slowly increasing angular velocity. Prior to rotation, each of the 0.60-kg sliding blocks has the position x = 29 mm with no force in its attached spring.
Water is flowing in a horizontal 200-mm diameter pipe at a rate of 0.05 m^3/s, and the pressures at sections 80 m apart are equal to 500 kPa at the upstream section and 400 kPa at the downstream section.
a wheel tractor scraper weighing 100 tons is being operated on a haul road which is now packed. this tractor is traveling fully loaded up a 6% slope to the dump site which is 0.5 miles away. the return trip is level and is also 0.5 miles away.
You are a construction engineer working on a large concrete foundation project, involving the placement of over 500,000 c.y of concrete. The construction site is adjacent to a salt-water source (bay) & it is decided to set up a concrete batch plan..
For a trapezoidal shaped channel (n=0.014 and slope = 0.0002 with a 20-ft bottom width and side slopes of 1:1.5 (V:H), determine the normal depth using trial and error technique for a discharge of 1000 cfs.
The siphon crown is 1.2m above the water surface elevation of the reservoir and a length 10m away from the siphon entrance. If the siphon diameter is 30 cm, if the friction factor is .02, and the headless coefficient are .2 (inlet) and 1 (exit),
Two soil samples, each having a void ratio of 0.76 and density of 2.65 grains have degrees of saturation, respectively, 85% and 100%. Determine the overall specific weight of each of the samples.
two 10 mm thick steel plates are fastened together by means of two 20mm bolts that fit tightly into the holes. if the joint transmits a tensile force of 45 kn determine the average normal stress in the plates at a section where no holes occur
Tall buildings can develop a significant difference in pressure between the inside and the outside of the building. Air lock entrances are used at the ground level so the pressure at the ground floor is not the same as atmospheric pressure.
Soil is excavated from a borrow to construct an embankment with a net volume of 50,000 cy with 95% of Modified Proctor maximum dry density of 110 pcf with a Modified Proctor optimum water content of 8%.
The air density is 0.00206 slugs/cuft. The car has frontal area of 19.8 sqft, a drag coefficient of 0.28, a wheel radius of 12.6 inches, a drive axle slippage of 3%, and a drivetrain efficiency of 88%.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd