Compute moment of the force about a line through origin

Assignment Help Civil Engineering
Reference no: EM13299825

The force F = 90i + 60j + 20k acts at the point (0,0,40). Compute the moment of the force about a line through the origin that has direction cosines (1/sqrt(3), 1/sqrt(3), 1/sqrt(3), 1/sqrt(3)).

Reference no: EM13299825

Questions Cloud

Era of enhanced communication : In this era of enhanced communication, discuss the benefits for having different state laws concerning criminal conduct, versus national standard statutes.
Difference between heavy lift and long lift surcharge : Difference between heavy lift & long lift surcharge and explain Long lift surcharge
What is the firm weighted-average cost of capital : a.) What is the after-tax cost of debt? b.) What is the cost of preferred stock? c.) What is the cost of common stock? d.) What is the firm's weighted-average cost of capital?
Find the minimum uncertainty in its momentum : A proton is confined to a nucleus that has a diameter of 8.3 × 10-15 m. what is the minimum uncertainty in its momentum
Compute moment of the force about a line through origin : The force F = 90i + 60j + 20k acts at the point (0,0,40). Compute the moment of the force about a line through the origin that has direction cosines (1/sqrt(3), 1/sqrt(3), 1/sqrt(3), 1/sqrt(3)).
Determine delta e(rxn) for the combustion of biphenyl : Find Delta E(rxn) for the combustion of biphenyl in kJ/mol biphenyl. The heat capacity of the bomb calorimeter, determined in a separate experiment, is 5.86 kJ/degrees Celsius.
Determine the current in the other wire : Two parallel wires separated by 4.3 cm repel each other with a force per unit length of 1.6 multiply.gif 10-4 Nm. Find the current in the other wire
Justify selecting this scale of operation : a.) What is the break-even level of output for each scale of operation? b.) What will be the firm's profits for each scale of operation if sales reach 5,000 units?
Advise periwinkle of its fbt consequences : How would your answer to (a) differ if Emma used the $50,000 to purchase the shares herself, instead of lending it to her husband and advise Alpha of the income tax consequences arising out of the above information for the 2013-14 income year.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine estimated unknown speed if the data were obtained

In an attempt to estimate the speed of a vehicle just before it hit a traffic signal pole, a traffic engineer measured the length of the skid marks made by the vehicle and performed trial runs at the site to obtain estimate if the coefficient of f..

  What is the lenght of the critical exterior flaw in the bar

A hot-rolled 7-mm-diameter steel rod is axially loaded at room Temp under a fully reversed cyclic loading. under the rotating beam test, the endurance limit for this steel is 470 MPA, under static loading the ultimate strenght is 1200 MPA.

  Find the force that these gas generates on the top

the circular top of a can has a radius of .0320m. the pull-tab has an area of 3.8x10^-4 m^2. the absolute pressure of the carbon dioxide in the can is 1.40x10^5Pa. find the force that these gas generates on the top of a can?

  Freeways density and level of service

What will the freeway's density and level of service be before and after the ban? (Assume that the trucks are removed and all other traffic attributes are unchanged).

  Compute the station and elevation of the curve turning point

Set up a table showing curve elevations at the PVC, at the PVT, and at the half-station points along the curve. Compute the station and elevation of the curve turning point.

  Find tensile stress that will give probability of failure

The median value of the rupture strength was 300 MPa. The ceramic is to be used for components with dimensions l=50mm, b=d=5mm loaded in simple tension along their length. Calculate the tensile stress that will give a probability of failure of the..

  What quantity of ice melts

A 3.60-g lead bullet at 28.0 degrees C is fired at a speed of 230 m/s into a large block of ice at 0 degrees C, in which it embeds itself. What quantity of ice melts?

  Case study-disaster identifying safety management

Conduct a Case Study on this disaster identifying safety management, safety audits, accident investigation, and industrial hygiene issues. Your Case Study should be a minimum of 500 - 600 words and contain the components listed above.

  Compute the factor of safety by using an effective stress

A 2:1 natural slope is underlain by a 3-m thick (measured vertically) soil cover over bedrock. Compute the factor of safety by using an effective stress infinite slope analysis with c'=0 and o' (theres a line between that)= 35 degrees for the soil..

  Probability of finding a bad rivet

Samples of 20 rivets for a steel structure are checked for quality every hour. The probability of finding a bad rivet that has to be scrapped is 1%.assume that x is the number of parts in the sample of 20 that have to be scrapped.

  Determine the depth that will result upstream during design

The design discharge is 9.5 m^3/sec and the inlet will be submerged but not the outlet. Determine the depth that will result upstream (above the invert) during the design flood event.

  What is elastic wave tomography

what is elastic wave tomography , flat jack, push shear test in masonary?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd