Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A manufacturing process involves heating long copper rods, which are coated with a thin film, in a large fur- nace whose walls are maintained at an elevated tem- perature Tw. The furnace contains quiescent nitrogen gas at 1-atm pressure and a temperature of T00 = Tw. The film is a diffuse surface with a spectral emissivity of sA = 0.9 for A 2 µ,m and sA = 0.4 for A > 2 µ,m.
(a) Consider conditions for which a rod of diameter D and initial temperature Ti is inserted in the furnace, such that its axis is horizontal. Assuming validity of the lumped capacitance approximation, derive an equation that could be used to determine the rate of change of the rod temperature at the time of insertion. Express your result in terms of appropri- ate variables.
(b) If Tw = T00 = 1500 K, Ti = 300 K, and D = 10 mm, what is the initial rate of change of the rod temperature? Confirm the validity of the lumped capaci- tance approximation.
(c) Compute and plot the variation of the rod temperature with time during the heating process.
Reheat, where high pressure and low pressure turbines are used, is added to a simple steam cycle to increase the steam quality at the location where the steam exits the low pressure turbine and goes to the condenser. Consider a steam cycle where the ..
Using the appropriate table, determine the indicated property. In each case, locate the state on sketches of the T-v and T-s diagrams. Include the vapor dome on the diagram.
a derive an expression for temperature distribution t r in the uo2 fuel of a pwr. assume that temperature of the
a disk of 180 mm radius rotates at the constant rate w212 radsec with respect to arm cd which itself rotates at the
Describe the principle and operation of an hearth furnace. Possible references: Making and Shaping of Steels by the American Society of Metals and Google resources.
air enters an adiabatic compressor at 20 degc and 100 kpa at a rate of 2 kgs and exits at 700 kpa. if the power input
the total solidification times of three casting shapes are to be compared 1 a sphere with diameter 10 cm 2 a cylinder
a 1.875 inch diameter shaft machined from aisi 1018 cd steel supports a bending load during operation at 1750 rpm. if
As a pickup truck (total mass of 2500 kg, including fuel and driver) approaches a rise in an otherwise flat road, the driver presses the clutch and begins to coast. Initially, the truck was moving at 26 ms. For many reasons, including friction losses..
some of our modern kitcgen cookware is made of ceramic materials. a compare the relative properties and cost of three
round your final answers to three decimal places. the liquid leaving the condenser of a 115000-btuh heat pump using
What is the difference between a force and a reaction - how many components of forces must be considered in pin and roller supports?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd