Compute and plot the psd for the rs-232 signal

Assignment Help Electrical Engineering
Reference no: EM13228484

The RS-232 serial port on a personal computer is transmitting 2400-bit/sec data using a polar NRZ line code that has a peak value of 12 V. Assume that binary 1's and 0's are equally likely to occur. Compute and plot the PSD for this RS-232 signal.

Reference no: EM13228484

Questions Cloud

Discuss the fourteen points and treaty of versailles : Discuss the Fourteen Points and Treaty of Versailles. What were Woodrow Wilson’s major goals? He didn’t get what he wanted, so explain what the results actually were, as represented in the Treaty of Versailles.
Describe the reactants and products : How many Joules of energy are stored in 1 pound (454 g) of sucrose? (Assume: Pressure = 1 atm, Temperature = 25°C; the respective ?Hf° for the reactants and products can be found in the thermodynamic table linked above. Show your calculation
European scramble for africa : Discuss the reasons behind the European “Scramble for Africa” in the late 1800s. Who started the ‘scramble’, why were the Europeans suddenly so desperate to acquire colonies (in Africa or elsewhere), and what allowed them to so easily conquer thes..
What is the complex admittance in siemens : An input signal of 10V at 0o is applied to a parallel RLC circuit with resistor R = 10 , inductive reactance XL = 20 , and a capacitive reactance XC = 10 . All three components are connected in parallel to the source.
Compute and plot the psd for the rs-232 signal : The RS-232 serial port on a personal computer is transmitting 2400-bit/sec data using a polar NRZ line code that has a peak value of 12 V. Assume that binary 1's and 0's are equally likely to occur.
State completely free of napoleons influencs : In 1810 the only european state completely free of napoleons influencs, and his major opponents was?
Explain the enclosure movement and the putting ot sysytem : Explain the reason why england was the first state to industializ. Be sure to explain the Enclosure movement and the putting ot sysytem and how they, and other specific advantages, combined to make england the first industrial state?
Which has the higher resistance in copper wire : which has higher resistance: the copper wire that carries the power from Bonneville Dam to your circuit breaker box, the copper wire that carries the power from there to your computer, or the copper wire that runs from the from one side of the chi..
Explain why the french revolution occured : Disucss the Problems and shortcomings of the French government during the late 1700s, which ultimately led to the french revolution of 1789? (Explain why the french revolution occured)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Make an appropriate substitution

Use the fact that x = 2 and y = 0 at t = 0 to determine the appropriate value of the arbitrary constant in the solution set.

  Compare the frequency response magnitudes

Compare the frequency response magnitudes for each of the responses above (will need to plot on a logarithmic scale). Comment on the observations noting things such as if the signals are resolvable, the size of the side lobes, etc.

  Explain problem on depletion-load amplifier

For the depletion-load amplifier, let W1=80microm, L1=4micrometers, W2=8 micrometers and L2=32 micrometers. If the body-effect parameter X=0.2, find the voltage gain neglecting the effect on ro.

  What is the range of the sensor voltage outputs initially

a. What is the range of the sensor voltage outputs initially and finally? b. What range of voltages would be expected to be measured 2 sec after the step change is applied?

  What is signal to noise ratio at the output of the amplifer

Assume you have a receiver with an overall noise figure of 23 dB and a bandwidth of 1 MHz. Assuming the minimum acceptable SNR at the output of the receiver is 6 dB, estimate the minimum detectable signal level in dBm at the receiver input.

  Find voltage regulation for load at leading power factor

A 3 phase Y connected alternator is rated at 1600 KVA, 13500 V. The armature resistance and synchronous reactance are 1.5 ohms and 30 ohms respectively. Calculate the % voltage regulation for a load of 1280 KW at 0.8 leading power factor.

  Determine what is the new cutoff frequency

A high-pass filter with C=30pF. R= 40 kohm A) What is the cutoff frequency The output of this filter is connected to an amplifier with an input resistance of 60 kohm. B) Sketch and label the new circuit. C) What is the new cutoff frequency

  How much current is flowing through the resistor

If I have a resistor that is 10 Ohms and has a voltage drop of 4.2 V, how much current is flowing through the resistor?

  What are the 2nd- and 3rd-order harmonics

A recording trace r(t) is definedas r(t) = s(t) + n(t), where s(t) =10sin(20?t) (i.e., a 10 Hz sine wave, given f= 2f) is the signal and n(t) = sin(120t) (i.e., the 60 Hz electromagnetic noise) the noise.

  Find percentage of electriciy generated by fuel cell system

Fuel cell systems that also utilize the heat produced can achieve efficiencies approaching 80 percent , more than double of the gas-turbine based electruiical generation . Assume that 25 million houuseholds produce an average of 5 kw.

  Determine the impulse response fpr the filter

Find the impulse response fpr the filter? How many nonzero terms does the impulse response contain?

  What is the group delay between a pulsar pulse

the solutions at both frequencies about a total transit time of 1000 years (speed of light in a vacuum result) such that subtracting one from the other leaves just the delay that is of order of 1 second.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd