Compressor with an internal energy

Assignment Help Mechanical Engineering
Reference no: EM13706639

Saturated steam at 230 degrees F, 20.78 psia and 19.386 ft cubed per pound of mass enters a compressor with an internal energy of 108.26 Btu/lb of mass and is compressed to 80 psia. the mass flow rate is 50 lb mass per hour. Heat loss from the compressor to the surroundings occurs at a rate of 112 btu/hr. The power input is 1.5HP. Find the enthalpy of the exit steam

Reference no: EM13706639

Questions Cloud

Air passes through a gas turbine system : Air passes through a gas turbine system at a rate of 4.5kg/s. It enters with a velocity of 150m/s and a specific enthalpy of 3000kJ/kg. At exit, the velocity is 120m/s and the specific enthalpy is 2300kJ/kg. The air has a heat loss to the surrounding..
Find the specific gravity of the material : A cube of material is 4 in. on a side and floats at the interface between kerosene and water, as shown in the figure. Find the specific gravity of the material.
Determine the stress-strain-youngs modulus : A steel rod of radius 0.01 m and length 2. M is pulled on with a tensile force of 200,000 N, and the bar stretches to a length of 2.08 m. The radius of the bar is reduced to 0.0099 m. Determine the stress, strain, Young's modulus (E), and Poisson's r..
Manufacturer claims the average velocity of air leaving fan : A fan with a diameter of 12 inches operates at a voltage of 120V with a current draw of 0.5 amps. The manufacturer claims the average velocity of air leaving the fan is 33.1 ft./s under standard conditions. Standard air has a density of 0.075 lb mass..
Compressor with an internal energy : Saturated steam at 230 degrees F, 20.78 psia and 19.386 ft cubed per pound of mass enters a compressor with an internal energy of 108.26 Btu/lb of mass and is compressed to 80 psia. the mass flow rate is 50 lb mass per hour. Heat loss from the compre..
Initial and final temperature of liquid due to heat transfer : A 50 kg hot iron block is dropped into a relatively cold lake at temperature T. During thermal equilibrium the lake receives Q amount of heat from the iron block. Show that the entropy change of the lake is Q/T starting with an expression for the spe..
Work required using the saturated liquid approximation : Saturated liquid water at 25 degrees C is pumped to a pressure of 5 MPa in an isothermal process. The specific work required by the pump to pressurize the water to 5 MPa can be found as the change in enthalpy of the water from the inlet pressure to t..
What is the interpretation of this corner frequency : Consider the first order system: y_dot + y = u where y is the output and u is the input, Plot the frequency response curves in Matlab using the analytic functions for the amplitude ratio and phase as a function of w. Plot the frequency response curve..
Temperature of the atmosphere varies with height : Using the hydrostatic law dp/dz = -(rho)g and the ideal gas law p = (rho)RT, show that if the temperature of the atmosphere varies with height as T(z) = T_o - Bz, then the atmospheric pressure varies with height as p(z) = p_o(1-(Bz/T_o))^(g/(BR))

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  During the same 10 minutes heat transfer occurs at a

2kg of air in a closed rigid tank is fitted with an electrical resistor. the resistor draws a constant current of 10

  Calculate the work done when a gas expands from 350kpa and

during some actual expansion and compression processes in piston-cylinder devices the gases have been observed to

  Airborne contaminant hazards explain

1.Discuss whether you think OSHA's air contaminant standards are important, and why. Do you think they are adequate to protect employees in the workplace from airborne contaminant hazards? Explain.

  Assume that the internal energy and specific volume of

the pressure of 200 kgs of water is to be increased from 1 atm to 4 mpa. the water enters through a 20-cm-diameter pipe

  Calculate the heat flux from the interior air to the wall

a wall has inner and outer surface temperatures of 16c and 6c respectively. the interior and exterior air temperatures

  If kinetic and potential energy changes of the air from

air is compressed at steady state from 1 bar 300 k to 6 bar with a mass flow rate of 4 kgs. each unit of mass passing

  Determine the specified property data at indicated states

For each case, determine the specified property data at the indicated states. Locate the state in sketches of the p-v and T-v diagrams.

  Water at 10 degrees c flows throug a smooth 60-mm-diameter

water at 10 degrees c flows throug a smooth 60-mm-diameter pipe with an average velocity of 8ms. would a layer of rust

  The atomic weight of copper is 635 gmol calculate its

the atomic weight of copper is 63.5 gmol. calculate its theoretical density given that it has fcc crystal structure and

  Steam at 1 bar enters an adiabatic heat exchanger with a

steam at 1 bar enters an adiabatic heat exchanger with a quality of 0.896 and exits as a saturated liquid. the steam is

  Cylindrical specimen of metal alloy in compression

A worker in factory wants to load a cylindrical specimen of metal alloy in compression. The elastic and shear modulus for this alloy is 105GPa and 39.7 GPa, respectively. If its original and final diameters are 20mm and 20.025mm respectively and its ..

  Determine torque and power required to rotate inner cylinder

The space between two 6 in. long concentric cylinders is filled with glycerin (viscosity = 8.5X10-3 lb s/ft2). The inner cylinder has a radius of 3 in. and the gap width between the cylinders is 0.1 in. Determine the torque AND power required to rota..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd