Component in the shape of a large rectangular sheet

Assignment Help Mechanical Engineering

Reference no: EM13718039

A component in the shape of a large rectangular sheet is made from AL-7075-T651. It carries uniform axial stress that may reach up to 50% of its yield strength. Assuming worst case scenario, what is the largest edge crack that can be allowed?

Reference no: EM13718039

Questions Cloud

Evaluate the thermal efficiency-carnot power cycle : One-half kilogram of water executes a Carnot power cycle. During the isothermal expansion, the water is heated until it is a saturated vapor from an initial state where the pressure is 1.5 MPa and the quality is 25%.

Determine the minimum theoretical value for TH in K : A power cycle operates between a reservoir at temperature TH and a lower-temperature reservoir at 280 K. At steady state, the cycle develops 40 kW of power while rejecting 1000 kJ/min of energy by heat transfer to the cold reservoir. Determine the mi..

Developed a device that executes a power cycle : An inventor claims to have developed a device that executes a power cycle while operating between reservoirs at 500 and 300 K that has a thermal efficiency of (a) 45%, (b) 40%, (c) 35%. Evaluate the claim for each case.

Maximum and minimum temperatures for the cycle : One kilogram of air as an ideal gas executes a Carnot power cycle having a thermal efficiency of 60%. The heat transfer to the air during the isothermal expansion is 40 kJ. At the beginning of the isothermal expansion, the pressure is 700 kPa and the..

Component in the shape of a large rectangular sheet : A component in the shape of a large rectangular sheet is made from AL-7075-T651. It carries uniform axial stress that may reach up to 50% of its yield strength. Assuming worst case scenario, what is the largest edge crack that can be allowed?

Design a single pass shell and tube type heat exchanger : Design a single pass shell and tube type heat exchanger which requires mh = 25 kg/s with Th,i = 30 C and mc = 75 kg/s with Tc,i = 20 C. What heat transfer rate is obtained using 150 2 m tubes (ID = 16 mm and OD = 19 mm with kw = 400 W/mK).

Coil for controlling the fermentation temperature : A helical cooling coil of 150 m in length and 12 cm in diameter inside a fermenter was used to maintain the temperature of a fermentation broth at 37 degrees C. When the coil was totally clean, only 15 kg/s cooling water at 12 degrees C were required..

Find the total friction losses and piping system : Water is pumped from a lake at ambient pressure and temperature to an elevation of 15 m through a pipe of 2-cm diameter galvanized iron at a flow rate of 0.00366 m3 /s. Assume the discharge is to open atmosphere. The pipe is 70 m long and has 2- 90o ..

Air enters turbine operating at steady state with pressure : Air enters a turbine operating at steady state with a pressure of 75 psi a temperature of 800°R and a velocity of 400ft/s. At the turbine exit the conditions are 15psi, 600°R and 100 ft/s. Heat transfer from the turbine to its surroundings takes plac..

User Account

All Pages