Comment on the water discharge rate for maximum power

Reference no: EM13560427

During the recent camping trip, a curious junior engineering student (like yourself) noticed that water is being discharged from a high reservoir to a stream in the valley through a 0.3 m diameter plastic pipe. The difference in elevation between the free surface of the reservoir and the stream is about 70 m. This junior engineer envisions that this could serve as a source of hydro-electric power.

Generate suitable design information to produce maximum power from this site. In addition, assess the effect of power generation on the discharge rate of water to mimick the potential seasonal variation of water available in the reservoir. Comment on the water discharge rate for maximum power generation.

Reference no: EM13560427

Questions Cloud

What is the bod5 of the river water : A 250 cubic meter reaction tank contains a waste water having an ultimate BOD concentration of 755 mg/L. If the BOD reaction rate constant is -0.352/day, how much BOD is remaining after 12.0 days?

Define the control variables and formulate the mathematical : No more than 12 units of TV, 40 units of radio and 25 units of direct mail are available. A minimum of 9 units of radio and 5 units of direct mail must be purchased.

Determine the increment of vertical stress there : Constructing the foundation causes changes in the levels of vertical stress at all points in the soil. One such point lies at the centre of the footing plan and is at a depth of 10m. Determine the increment of vertical stress there.

Find the maximum principal effective stress at failure : Given the initial effective stress state at a point within a soil mass (s_y=2.5 daN/cm2, s_x=1.5 daN/cm2, t_xy=t_xy=0.4 daN/cm2) and effective soil shear strength parameters at the same point (friction angle=30 degrees, cohesion=0.5 daN/cm2)

Comment on the water discharge rate for maximum power : During the recent camping trip, a curious junior engineering student (like yourself) noticed that water is being discharged from a high reservoir to a stream in the valley through a 0.3 m diameter plastic pipe. The difference in elevation between the..

Calculate the amount of suspended solids : A sedimentation basin is used to remove suspended solids from a wastewater. The rate of flow of wastewater into the tank is 10 L/s, and the influent concentration of suspended solids is 200 mg/L.

Calculate the detention time horizontal flow-through : A flocculation basin equipped with revolving paddles is 60 ft long (the direction of flow). 45 ft wide, and 14 ft deep and treats 10 mgd. The power input to provide paddle-blade velocities of 1.0 and 1.4 fps for the inner and outer blades,

Determine the dimensions of the pit that minimize cost : You are asked to design a covered conical pit to store 50 m3 of waste liquid. Assume excavation costs at $100/m3, side lining costs at $50/m2, and cover cost at 25/m2

Develop one additional question that you think susan have : Mike and Susan hope to retire a few years early, they decided to pay closer attention to the predicted amount of retirement benefits and do some analyses on the numbers.

User Account

All Pages