Comment on the production control situations

Assignment Help Applied Statistics

Reference no: EM13336892

Q. Comment on the production control situations depicted by the four control charts shown on the following page, and state what action, if any, would be necessary in each case.

2091_Statistical Process Control3.png

Reference no: EM13336892

Questions Cloud

What is the magnitude of electric field produced by shell : A hemispherical shell of radius a=1 cm has a surface charge density of m=4.00 uC/m^2. What is the magnitude of the electric field produced by the shell at the spherical center

Find the focal length of the objective : A -100× microscope has an eyepiece whose focal length is 4.5cm. find the focal length of the objective

What is the lateral magnification : An object is placed 8cm in front of a converging lens with a focal length of 18cm. What is the lateral magnification

Explain what is the pressure at 15 degree c : 1) a sample measures 711mmHg pressure at 15 degree C. Later the temperature goes to 45 degree C. What is the new pressure 2) a gas is at 45.2 atm and 51 degree C. what is the pressure at 15 degree C

Comment on the production control situations : Comment on the production control situations depicted by the four control charts shown on the following page, and state what action, if any, would be necessary in each case.

Determine the diameter of your coil : You have a 1.3m long copper wire. You want to make an N-turn current loop that generates a 1.0mT magnetic field at the center when the current is 1.2A. What will be the diameter of your coil

At what angle in degrees should the strip be placed : a) At what angle (in degrees) should this strip be placed to yield an apparent focal spot size 2.5 mm x 1.5 mm. b) Using this size target, what angle is required to obtain a 2.5 mm x 2.5 mm apparent focal spot

How far are you from the pole : If you hold a 900cm2 square plane mirror 43cm from your eyes and can just see the full length of an 7.7m flagpole behind you, how far are you from the pole

Design and sketch an average control chart : Design and sketch an average control chart, showing upper and lower design limits, upper and lower action limits, and nominal value. Calculate and state the range control limit value.

User Account

All Pages