Classify the variable of interest as nominal or ordinal

Assignment Help Electrical Engineering
Reference no: EM13250048

A consumer protection agency conducts opinion polls to determine the quality (excellent, good, fair, bad) of products imported. if the agency conducted a poll in wich 1000 randomly selected individuals were contacted by telephone.

A. What is the population of interest?

B. What is the sample?

C. Classify the variable of interest as nominal, ordinal, interval, or ratio.

Reference no: EM13250048

Questions Cloud

Find the position of vectors r1 and r2 for p and q : Consider points P(2,4,3) and Q(1,-5,2) in three dimensional space: Find the position of vectors r1 and r2 for P and Q in terms of unit vectors i,j,k Determine graphically and analytically the resultant of these position vectors Hint: resultant vector..
Explain a radioactive decay the half-life : For a radioactive decay (decomposition of a radioactive substance) the half-life is 6.0 h. How much radioactive substance remains after 22 h, in % (radioactive decay is a first-order process)
What are the business benefits of bi : What are the business benefits of BI (Business Intelligence) deployments and the main challenges required to extend BI tools beyond mere reporting?
What experiences and qualifications are important : What experiences and qualifications are important in preparing managers for "fact-based" decision making and how are the skills needed for DSS obtained?
Classify the variable of interest as nominal or ordinal : A consumer protection agency conducts opinion polls to determine the quality (excellent, good, fair, bad) of products imported. if the agency conducted a poll in wich 1000 randomly selected individuals were contacted by telephone.
Explain the ph of an aqueous portion of the mobile phase : HPLC analysis of basic analytes is better to perform at low pH when they are fully ionized (2 pH units lower than analyte pKa). For the analyte with pka= 5.6 and 60/40 acetonitrile/water eluent composition what should be the pH of an aqueous porti..
Is second-mover advantage always a good business strategy : What can a front-runner business do to foil the assaults of second movers? Is the second-mover advantage always a good business strategy?
Define why selectivity in isocratic hplc system : Explain why selectivity in isocratic HPLC system ideally should not depend on eluent composition. Use thermodynamic derivation to support your explanation.
Discuss the reasons for such high failure rates : Although ERP (Enterprise Resource Planning) Systems are a great concept. Implementation of such systems have a high rate of failure and often after such systems are installed the results may not be as desired.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How the uart can be used to fill an instruction ram

Instead of recreating the design every time we change the instruction ROM, we want to have a way to change the instructions while the system is running. Discuss how the UART can be used to fill an instruction RAM instead

  Compare the area-delay and power of the adders

Design a 16 bit adder using both the ripple carry and CLA methods. Use 4-bit CLA blocks for the carry-lookahead design. Use only two-input logic gates in your design. Simulate the design using LogiSim at the logic gate level.

  Use microsoft excel to compare costs

Use Microsoft Excel to compare costs from at least three different vendors and reasons to accept specific bids. (May use graphs in Excel to provide a better visual comparison)

  What are the resistance value and tolerance

Look at the resistor illustrated. Based on your knowledge of the resistor color code, what are the resistance value and tolerance of this resistor?

  Explain resisitive load

Resisitive load, A 4:1 step down transformer uses a 60Vac source on the primary windings.

  Determine the minimum order of the filter at sampling rate

the -3 dB frequency for low pass Butterworth filter is 2.5 kHz. The stop band begins at 3.8 kHz, with an attention of 35 dB. Determine the minimum order of the filter if the sampling rate is 8 kHz

  Find the total loss through the guide and the phase delay

A 10 cm length of a K-band copper waveguide is filled with a dielectric material with er = 2.55 and tan f = 0.0015. If the operating frequency is 15 GHz, find the total loss through the guide and the phase delay from the input to the output of th..

  Electrical wiring: potentials of neutral and earth wires

Electrical wiring: Potentials of neutral and earth wires, Why is the neutral wire in housing circuits also at zero potential

  What is the per unit value if we change the base

A generator is rated at 500 MVA (three phase) and 22 kV (line-to-line). Its Y-connected windings have a reactance of 1.1 per unit. Find the ohmic value of the reactance of the windings. What is the per unit value if we change the base to 200 MVA a..

  Determine the electrostatic force acting on the electron

Consider a classical model of a hydrogen atom, with nucleus of charge -e orbited by an electron of charge +e, where e = -1.6×10-19 C. If these may be modeled as point charges separated by 0.053 nm, determine the electrostatic force acting on the e..

  Design the basic interface circuit for a temperature sensor

Design the basic interface circuit (using an op amp) for a temperature sensor that covers a range of 0 degrees to 70 degrees C if the output of the sensor is 2 mV/1C and the ADC voltage range is 0 to 4 V.

  Design a critically damped series rlc circuit

Using the commonly available resistors, capacitors, and inductors, design a critically damped series RLC circuit (i.e., all three components are connected in series) with an undamped natural frequency of 20 krad/s.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd