Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
CIVE461 - Highway Engineering - American University of Beirut
Learning Outcome 1: Students will know the fundamental principles of highway engineering: roadway characteristics, highway location, and geometric design.Learning Outcome 2: Students will have the ability to apply fundamental concepts in design of geometric alignment of highways.Learning Outcome 3: Students will have the ability to apply the principles of highway planning (traffic forecasting).Learning Outcome 4: Students will have acquired the fundamental abilities to design highway facilities.Learning Outcome 5: Students will have the ability to design parking facilities.Learning Outcome 6: Students will maintain/develop their knowledge of and familiarity with latest software tools for highway geometric design.Learning Outcome 7: Students will have the opportunity to interact with their peers.
To design highways, need to understand the characteristics of the 4 components and know their limitations
Attachment:- Highway Engineering.rar
Water is pumped from the tank 1 to tank 2 as shown below. The suction side pipe is nominal 5, schedule 40, 24 ft long, f = 0.018, and the discharge pipe is nominal 4, schedule 40, f = 0.019
Determine the maximum grade on which passenger car A can travel without its total resistance exceeding that of car B traveling on a straight and level section of road.
The point of intersection of the tangents is located at station (948+67.32). If the design speed of the highway is 60mi/h, determine both the point of tangent and the deflection angles to whole stations for laying out the curve. Select appropriate..
A galvanized (zinc-coated) steel sheet is found to uniformly corrode with an average current density of 1.4 X 10-7 A/cm2. How many years will it take to uniformly corrode a thickness of 0.030 mm of the zinc coating?
Determine the discharge of a trapezoidal concrete channel section with a bottom width of 4 ft and side slopes of 2:1. The depth of flow is 5 ft and the channel slope is 0.5%
Describe the problem of lack of coordination between design and construction in a traditional contract. In agency CM,what expertise does the CM provide during the pre-design and design phase.
Consider the problem described in E11.25, where a sine wave is fit over the range -2- £ p £ 2. Select 11 training points evenly spaced over this interval.
a consolidated-drained triaxial shear test on a normally consolidated clay yielded a drained friction angle of 28
The shaft diameter is 100 mm. Calculate the largest principal stresses and maximum shear stress that will occur in the shaft.
Consider a house into which radon is emitted through cracks in the basement. The total volume of the house is 650 m3 (assume that the volume is well mixed throughout).
A sample of dry sand with a specific gravity total of 16.49 kN/m3 and a relative density of 2.67 grains, is placed outdoors. During a rainy period, the sample volume remains constant but the degree of saturation increases to 40%.
Two level sections of an east-west highway (G = 0) are to be connected. Currently, the two sections of highway are separated by a 4000-ft (horizontal distance), 2 % grade. The westernmost section of highway is the higher of the two and is at eleva..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd