Choose direction of incoming ball as positive direction

Assignment Help Physics
Reference no: EM13565026

A baseball (m = 145 g) approaches a bat horizontally ata speed of 40.9 m/s (91.5 mi/h) and is hit straight back at a speedof 51.7 m/s (116 mi/h). If the ball is in contact with the bat fora time of 1.44 ms, what is the average force exerted on the ball bythe bat? Neglect the weight of the bat, since it is so much lessthan the force of the bat. Choose the direction of the incoming ball as the positive direction.

Reference no: EM13565026

Questions Cloud

Performance test problem : In a performance test, each of two cars takes 8.0 s to acceleratefrom rest to 28 m/s. Car A has a mass of 1429 kg, and car B has amass of 1876 kg. Find the net average force that acts on(a) car A and (b) car B duringthe test.
Telescope-observe two distant point sources transversely : A telescope is used to observe two distant point sources transversely 2.50 {\rm m}apart with light of wavelength 600 {\rm nm} .The objective of the telescope is covered with a slit of width0.350 {\rm mm} .
A model rocket is constructed with a motor : A model rocket is constructed with a motor that can provide a total impulse of 39.0 N·s. The mass of the rocket is 0.229 kg. What is the speed that this rocket achieves when it is launched from rest? Neglect the effects of gravity and air resistance.
Four insulated wires overlapping one another-forming squae : The drawing shows four insulated wires overlapping one another, forming a square with 0.050-m sides. All four wires are much longer than the sides of the square. The net magnetic field at the center of the square is 72 μT directed into the drawing..
Choose direction of incoming ball as positive direction : A baseball (m = 145 g) approaches a bat horizontally ata speed of 40.9 m/s (91.5 mi/h) and is hit straight back at a speedof 51.7 m/s (116 mi/h). If the ball is in contact with the bat fora time of 1.44 ms, what is the average force exerted on the..
Estimate the blade radius of the wind turbine : Total required annual electrical energy output from the wind farm =120 TJ Max number of turbines for which there is space on the farm =20. Average annual wind speed at the site= 9.0 ms^-1
What is temperature at steel cu surface and heat rate rod : A 60 cm long steel rod with a diameter of 4 cm is mated to a 40 cm long Cu rod with the same diameter. the unmated end of the steel rod( not at the interface) is connected to a 140 degrees C heat source, while the far end of the Cu( not at the int..
Find the angles of the reflected and refracted rays : Incident light in air impinges on a diamond. If the angle of the incident ray is 60°from the normal find the angles of the reflected and refracted rays. The speed of light in adiamond is 1.23932x108m/s.
Illusionist causes a valuable piece of jewelry apparently : An illusionist causes a valuable piece of jewelry apparently to disappear by dropping it in a pool of water directly under the center of a circular platform floating on the surface. Find the minimum diameter of the platform that would prevent the ..

Reviews

Write a Review

Physics Questions & Answers

  Find the magnitude of the resulting magnetic field

A sphere of radius R is uniformly charged to a total charge of Q. It is made to spin about an axis that passes through its center with an angular speed ω. Find the magnitude of the resulting magnetic field at the center of the sphere.

  Find the equivalent resistance

A resistor is in the shape of a cube, with each side of resistance  R . Find the equivalent resistance between any two of its adjacent corners.

  What is the electric field at the location

Question: Field and force with three charges? What is the electric field at the location of Q1, due to  Q 2 ?

  What is the maximum displacement of the bridge deck

What is the maximum displacement of the bridge deck?

  What is the magnitude of the current in the wire

What is the magnitude of the current in the wire as a function of time?

  Blackbody

Questions on blackbody, Infra-Red Detectors & Optic Lens and Digital Image.

  Gravity conveyor

Illustrate the cause of the components accelerating from rest down the conveyor.

  Calculate the dc voltage

Calculate the dc voltage applied to the circuit.

  Quadrupole moments in the shell model

Quadrupole moments in the shell model

  Determine the tension in each string

Determine the tension in each string

  Introductory mechanics: dynamics

Calculate the smallest coefficient of static friction necessary for mass A to remain stationary.

  Evaluate maximum altitude

Evaluate maximum altitude?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd