Calculate what was the students associated reaction time

Assignment Help Civil Engineering
Reference no: EM13312646

An engineering student is driving on a level roadway and sees a construction sign 600ft ahead in the middle of the roadway. The students strikes the sign at a speed of 35mi/h. If the student was travelling at 55mi/h when the sign was first spotted, what was the student's associated reaction time( use practical stopping distance)?

Reference no: EM13312646

Questions Cloud

Explain the 1h nmr spectrum of diethyl ether : Which of the following combinations of peaks appears in the 1H NMR spectrum of diethyl ether, CH3CH2OCH2CH3? a. a triplet and a doublet b. a quartet and a sextet c.
Explain the splitting of the signal in the 1h nmr spectrum : What is the splitting of the signal in the 1H NMR spectrum for the methyl protons of ethane? What is the splitting of the signal in the 1H NMR spectrum for the methyl protons of 1-bromo-2-methylpropane? Please explain?
What average force acted upon the car : A 14,240N car is traveling along a highway at 95.0 kn/hr. If the driver immediately applies his breaks, what average force acted upon the car
What is ma the moment that tends to twist the telephone : An old wooden telephone pole with a single cross member was blown off center during a recent storm. To temporarily stabilize the telephone pole, a repair crew has attached a cable from the end of the cross member to an eye-ring stake anchored in t..
Calculate what was the students associated reaction time : The students strikes the sign at a speed of 35mi/h. If the student was travelling at 55mi/h when the sign was first spotted, what was the student's associated reaction time( use practical stopping distance)
How to write a balanced equation for the reaction : Write a balanced equation for the reaction between O2 and H2. ( I know its H2O but I want to make sure there is nothing left over from O2)
What is the viscous force resisting the motion : A hydraulic ram 200mm in diameter and 1.2 m long moves wholly within a concentric cylinder 200.2mm in diameter, What is the viscous force resisting the motion when the ram moves at 120mm . s-1
Explain why should care be exercised in the preparation : Why should care be exercised in the preparation of the column to prevent air bubbles from being trapped in the absorbent
Determine what is the decrease in thickness of the 6-ft fill : A loose, uncompacted sand fill 6 ft in depth has a relative density of 40%. Laboratory tests indicated that the minimum void ratios of the sand are 0.46 and 0.90, respectively. The specific gravity of solids of the sand is 2.65.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Find out velocity head expressed in atmospheres

What is the velocity head expressed in atmospheres for a rapid filter operated at a surface loading rate of 475 m/d when the local porosity is 0.40?

  Explain plan for construction of a small child care center

describe how would you develop a subcontracting plan for the construction of a small child care center

  How to write the appropriate interest-factor equation

The first alternative is deep-well pumping at an annual cost of $10500. The second alternative is to instal an 18 inch diameter pipeline from a local surface reservoir at a first cost of $25000 and an annual pumping cost of $7000.

  Determine annual volume of solid waste produce by source

the bailey stone works employs six people. assumming that the density of uncompacted waste is 480 kg/m^3, determine the annual volume of solid waste produce by the stone works assumming a waste generation rate of 1 kg/cap*d.

  Design a cantilever

Need to design a cantilever retaining wall 8m high, saturated unit weight is 16kn/m 3 , surcharge is 7kn/m 2 , load above wall supported on wall stem

  Determine the initial specific discharge under the gate

Write out the continuity and momentum equations that govern the surge travelling downstream. (Note: assume that the surge velocity exceeds the water velocity)

  Develop a simple urban constructed wetland design

Develop a simple urban constructed wetland design.

  Determine the components of the 800 lb force f along axes

determine the components of the 800 lb force f along the oblique axes a and b. also, determine the projections of f onto the a and b axes

  Compute evaporation rates in the winter and in the summer

At a certain location during the winter, the average air temperature is 10 degrees celcius and the net radiation is 40W/m^2 and during the summer the net radiation is 200W/m^2 and the temperature is 25 degrees celcius.

  Explain how the difference in piezometric pressure

A manometer is used to measure the pressure difference between points A and B in a pipe. Water flows in the pipe, and the specific gravity of the manometer fluid is 2.8. The distances and manometer deflection are indicated.

  Whether proportional limit is exceeding for either material

To prevent this high compression load from buckling the copper pipe, a solid steel support of 2 1/2 inch diameter is placed inside the copper pipe. The copper pipe is 8.000 inches long. The steel support is 8.0001 inches (exactly 1 mil = 1/1000 in..

  Determine the angle of twist

A beryllium copper wire having diameter of 1-50 mm and length of 40mm is used as a small torsion bar in an instrument. determine what angle of twist would result in the wire when it is stressed to 250 mpa.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd