Calculate what the average power emitted is in transistor

Assignment Help Electrical Engineering

Reference no: EM13251732

a) Outpunts on the RTL link in the figure above has the following parameters:

Power supply voltage Vcc = 5.0 volts

Resistance R = 100 Ohm

Channel resistance RDS on = 0.1ohm ^ 2

Threshold voltage VTH = 2.0 Volt

A clock signal is connected to input A, i.e G(ate) input of the transistor. When the signal is high "1" the transistor is on. When the signal is low "0" the transistor is off.

What is the minimum voltage the clock signal must have in the high state for the transistor to be on?

What current I will go from Vcc to ground (GDS)?

b) calculate what the average output power supply must deliver to the logical link.

Calculate also what the average power emitted is in the transistor.

Tips: General formula for power is P = V x I = R x I^2

Reference no: EM13251732

Questions Cloud

Which one does a project manager have least control over : Which metric does a project manager have most control over: cost variance, schedule variance, cost performance index, and schedule performance index? Explain how so. Which one does a project manager have least control over?

Voltage clamp experiment : A sea urchin egg is used in a voltage clamp experiment; that is, the value of the transmembrane voltage is set by the experimenter, not by the properties of the membrane. The transmembrane voltage is held at +10 mV for one minute

Communicate the status of quality during a project : While cost and time are critical components of projects, how would you define the quality of a project? Provide some examples of project reporting metrics a project manager could use to measure and communicate the status of quality during a projec..

Find the height of the two balls when they are passing : A ball is dropped from rest from the top of a building of height h. What is the height of the two balls when they are passing

Calculate what the average power emitted is in transistor : A clock signal is connected to input A, i.e G(ate) input of the transistor. When the signal is high "1" the transistor is on. When the signal is low "0" the transistor is off. What is the minimum voltage the clock signal must have in the high state..

Use in protecting spaz or pimples : Suppose the state in which Spaz is located has a standard merchants protection statute. Why would this statute be of no use in protecting Spaz or Pimples?

What is the binding energy of lithium : A Li-6 nucleus has a mass of 6.015121 u The mass of a single proton is 1.007276 u, What is the binding energy of lithium

What can you learn from customer relationship management : what can you learn from customer relationship management? and a detailed explanation of the benefits of the SAP module.

Find the width of the central maximum : Ligh of wavelength 610 nm is incident on a slit 0.20 mm wide, what is the width of the central maximum

User Account

All Pages