Calculate vapor flow rate through wall and vapor pressure

Assignment Help Mechanical Engineering

Reference no: EM13713217

An outside wall of a building is constructed of 1/2 inch gypsum sheeting, 8 inches of concrete block (hollow, 3 oval core), and 4 inches of common brick. The inside of the building is maintained at 75F dry-bulb temperature and 65F wet-bulb temperature. Barometric pressure is 14.696 psia. Outside conditions are -30F dry bulb temperature and 80% relative humidity. Outside wind velocity is 15 mph.

a) Calculate the heat transmission through the wall and the temperatures at each surface and interface.

b) Assume vapor flow continuity and calculate the vapor flow rate through the wall and the vapor pressure at each surface and interface.

c) Will condensation occur based on your results?

d) How many layers of 1/2 inch insulation board (k=0.36 Btu/hrft^3F/in) must be added to the wall to prevent condensation on the inside surface

Reference no: EM13713217

Questions Cloud

How much work w is done by the electrostatic force : A point charge with charge q1 is held stationary at the origin. A second point charge with charge q2 moves from the point (x1, 0) to the point (x2, y2). How much work W is done by the electrostatic force on the moving point charge.

What is the potential difference across this coil : A coil has 2.85 Ohm resistance and 127 mH inductance. If the current is 3.1A and is increasing at a rate of 3.5A/s, what is the potential difference across this coil at this moment.

What is the net gravitational force on sphere m2 : Three spheres are placed at the corners of a right triangle as shown below. If m1 = 3.00 kg, m2 =5.00 kg, and m3 = 9.00 kg. What is the net gravitational force on m2.

What is the application layer protocol involved : What is its transmission distance from radio to radio - What is the security method used and discuss if the creation of a Wi-Fi Direct multi-hop network is possible or not.

Calculate vapor flow rate through wall and vapor pressure : An outside wall of a building is constructed of 1/2 inch gypsum sheeting, 8 inches of concrete block (hollow, 3 oval core), and 4 inches of common brick. The inside of the building is maintained at 75F dry-bulb temperature and 65F wet-bulb temperatur..

Calculate the current in the resistor : A 2.00-nF capacitor with an initial charge of 4.97 µC is discharged through a 2.04-k Ω resistor. Calculate the current in the resistor 9.00 µs after the resistor is connected across the terminals of the capacitor.

Manufacturing space with an average floor to ceiling height : A large manufacturing space with an average floor to ceiling height of 30 ft has a floor area of 5000 ft^2. The total infiltration rate for the space is estimated to be 1.5 air changes per hour. The inside design temperature and relative humidity are..

What is the initial velocity of the rock : A rock is thrown vertically up to the air. It reaches a maximum 15 m above the point where it was released. What is the initial velocity.

Importance of structural mechanics in mechanical engineering : Briefly discuss the importance of Structural Mechanics in Mechanical Engineering? List four different types of loadings that can be applied on mechanical structures or components

User Account

All Pages