Calculate the work needed to move a 3 c charge

Assignment Help Electrical Engineering
Reference no: EM13277478

Let E = y ax V/m at a certain instant of time, and calculate the work needed to move a 3 C charge from (1,3,5) to (2,0,3) along the straight line segment joining:
a.) (1,3,5) to (2,3,5) to (2,0,5) to (2,0,3);
b.) (1,3,5) to (1,3,3) to (1,0,3) to (2,0,3)

Reference no: EM13277478

Questions Cloud

Find the net amount of charge contained in a cube on edge : it is found experimentally that electric field in certain region of earth's atmosphere is downward. at an altitude of 300m the field is 58N per C and at altitude of 200m it is 110N per C. Find the net amount of charge contained in a cube 100m on e..
Find the difference in cyclotron frequencies for the two ion : Cyclotrons are sometimes used for carbon-dating by accelerating singly ionized C14 and C12 ions from a sample of material. find the difference in cyclotron frequencies for the two ions
Define the nitrate ion reaction is positive : The nitrate ion reaction is positive. In this case, is it accurate to state that nitrate ion was present in the original solution? Brie?y explain, referencing specific chemical reactions to support your explanation.
Corporation argue for various corporate governance : Today, critics of the corporation argue for various corporate governance reform proposals to improve the legal, moral, and socially responsible behavior of the corporation. Which of the following is the most convincing argument for these proposals?
Calculate the work needed to move a 3 c charge : Let E = y ax V/m at a certain instant of time, and calculate the work needed to move a 3 C charge from (1,3,5) to (2,0,3) along the straight line segment joining: a.) (1,3,5) to (2,3,5) to (2,0,5) to (2,0,3)
Compute the magnification of the telescope : An astronomical telescope uses an eyepiece of power +80.000 D. what is the magnification of the telescope
Find vmn if point m and n are specified by m and n : An electric field is expressed in rectangular coordinates by E = 6x2ax + 6y ay +4az V/m. Find: a.) VMN if point M and N are specified by M(2,6,1) and N(-3, -3, 2). b.) VM if V = 0 at Q(4, -2, -35)
Mandatory-random-observed drug testing : Mandatory, random, observed drug testing by an employer ethically could be deemed:
Evaluate the cell potential for the reaction : Calculate the cell potential for the following reaction as written at 61 °C, given that [Cr2 ] = 0.826 M and [Ni2 ] = 0.0200 M. Cr(s) + Ni ^2+ (aq) --> Cr^2+ (aq) + Ni(s)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What electrical code is universally used in the united state

Identify the type of cable that is permitted in single- and multifamily dwelling units but that cannot be used underground, nor in buildings that are more than three stories above grade, nor in commercial garages, motion picture studios, theaters,..

  What is the system power factor and supply current per phase

Three parallel three-phase loads are supplied from a 207.85-V rms, 60-Hz three-phase supply. The loads are as follows: Load 1: A 15 hp motor operating at full load, 93.25 percent efficiency, 0.6 lagging power factor.

  Indicate the peak current in each of the resistors

R1=1k ohms, R2=1.5k ohms and R3=3k ohms. Assume an ideal opAmp. Indicate the PEAK current in each of the resistors.

  How much energy is exchanged when a charge moves

The terminals of an electrical device are labeled a and b. If vab = 10V , how much energy is exchanged when a charge of 3 C moves through the device from a to b. Is the energy delivered to the device (i.e., device dissipating or storing energy).

  How much current flows through the light bulb

Using the symbols we've learned in class (standard symbols used universally), draw a schematic showing the circuit of a 12-V car battery (represented as a voltage source connected to a light bulb (represented as a resistor).

  Compute the current in the element as a function of time

The power delivered to the element is p(t) = 0.60e-4t W. Compute the current in the element as a function of time, the voltage across the element as a function of time, and the total energy delivered to the element in the time interval 0

  Create a circuit using only the basic gates-not-and-nor

A 6-bit answer based on the selected Operation. The error bit is turned on if either no Operation is selected or more than one Operation is selected.

  Explain signals obtained separately in the radio receiver

How are the left (L) and right (R) signals obtained separately in the radio receiver to drive the dual channel audio amplifier and speakers?

  Create an absolute value component abs with an 8-bit input

Create an absolute value component abs with an 8-bit input A that is a signed binary number , and an 8-bit output Q that is unsigned and that is the absolute value of A. So if the input is 00001111(+15) then the output is also 00001111(+15)

  Determine the generated voltage and the kw rating

A four pole DC machine has a wave winding of 300 turns. The flux per pole is .025 webers. The DC machine rotates at 1000 RPM. Determine the generated voltage and the kW rating if the current through the turn is 25 amps.

  What charge must be on each plate

An electric field of 3.10×105 is desired between two parallel plates, each of area 36.0 and separated by 0.620 of air.What charge must be on each plate?

  Express the sum of products expression for the minimal cover

Consider the function f(A,B,C,D) = fm(0,1,4,5,8,9,13,14,15) 1. Map the function, and obtain a minimal sum of products cover.  2. Express the sum of products expression for the minimal cover. F (SOP)

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd