Calculate the work done by vector

Assignment Help Physics

Reference no: EM13320807

A construct force vector F = 2.0i + 4.0j N acts on an object as it means along a straight- line path. If the object is displacement is d = 2.0i + 5.0j m calculate the work done by vector F using these alternate ways of writing the dot product.

(A) Calculate the work done by vector F using these alternative ways of writing the dot product W = Fdcos(theta).

(B) Calculate the work done by vector F using these alternate ways of writing the dot product W = F_x dx + F_y dy.

Reference no: EM13320807

Questions Cloud

Make forecasts for their sales territories : A request has gone out to all salespeople in a company to make forecasts for their sales territories for next year. These forecasts will be aggregated by product lines, districts, and regions, and -finally, at the national level.

What will be the ratio of mass of natural gas in the tank : At a given initial time, the pressure in thetank is 100 kPa gage, and the atmospheric pressure is 100 kPaabsolute. Some time later, after more gas is pumped into thetank, the pressure in the tank is 200 kPa gage, and the temp.

What is the slit width : The first two dark fringes on one side of the central maximum in a single-slit diffraction pattern are 1.0 mm apart. What is the slit width

Compared to the process without inventory : Consider the six-step process in the Process 1 tab where the processing time for each step is uniformly distributed, for which processing times can range from 12 to 18 minutes (any value in that range is as likely to occur as any other in that range)..

Calculate the work done by vector : A construct force vector F = 2.0i + 4.0j N acts on an object as it means along a straight- line path. If the object is displacement is d = 2.0i + 5.0j m calculate the work done by vector F

Determine the density in si unit of brass : The specific weight (wt./Vol.) of brass is 520 lb/ft^3. Determine its density (mass/vol.) in SI units. Use an appropriate prefix.

Determine how many tons of aggregate will be needed : Base course aggregate has a target dry density of 119.7 lb/cu ft in place. It will be laid down and compacted in a rectangular street repair area of 2000 ft*48ft*6in.

What is the total work done by the two tugboats : Two tugboats pull a disabled supertanker. Each tug exerts a construct force of 2.00 x 10^6 N, What is the total work done by the two tugboats on the supertanker

What torque is required to drive the disk at 760 rpm : A flat disk spins within an oil-filled enclosure. Clearances between the enclosure to both sides of the disk is 2.3 mm. The disk surface (area subject to shear) extends from radius 10mm to 90 mm.

User Account

All Pages