Calculate the water content and degree of saturation

Assignment Help Civil Engineering
Reference no: EM13563847

1.A particular soil has a total (moist) unit weight of 122 pcf and a dry unit weight of 101 pcf. The specific gravity of soil is 2.70. Calculate the water content and degree of saturation.

2.A specimen of saturated soil has a water content of 145 percent and a total unit weight of 84 pcf. Find the void ratio and specific gravity of solids.

3.Given a force with components [120, 330, -150] lbs acting at the point [10, 14, 0] inches, find the moment that this force creates about the point with coordinates [4, -5, 2] inches.

4.A jet of water of diameter 75mm moving with a velocity of 25m/s strikes a fixed plates in such a way that the angle between the jet and plate is 60? find the force exerted by the jet on the plate. (a) In the direction normal to the plate and (b) In the direction of the jet

Reference no: EM13563847

Questions Cloud

Determine the maximum negative moment in each span : A three span continuos beam has spans of 27, 30, 27 feet, total unfactored dead loads are 2,600 pounds per linear foot, unfactored live loads are 2,000 pounds per linear foot. For load combination 1.2D + 1.6L
Plot the shear and moment diagrams for the beam : Given simply supported beam with an overhang. The beam is 12 inches wide by 24 inches deep, and the slab is 6 inches deep. use a roof live load of 20 psf, and a concrete density of 150 pdf
How much sand did he place in the drum : A truck driver used sand to soak up a 1 g spill of lindane (C6H6Cl6). He placed the contaminated soil in an open drum which then filled with 150 L of water during a rainstorm. You test the water and find a concentration of 17 M.
What is the generic soil cleanup criteria for direct contact : Based on Michigan law, (a) what is the generic soil cleanup criteria for direct contact with residential soils contaminated with lead? Report your answer in units of "ppm" (
Calculate the water content and degree of saturation : A jet of water of diameter 75mm moving with a velocity of 25m/s strikes a fixed plates in such a way that the angle between the jet and plate is 60? find the force exerted by the jet on the plate. (a) In the direction normal to the plate and (b) In t..
The self resistance of a practical inductor : The self resistance of a practical inductor is (A) in series with the inductance. (B) in parallel with the inductance. (C) responsible for storing the magnetic energy. (D) No correct answer listed Capacitive reactance XC is:
Calculate the depth of flow upstream of the bridge : Calculate the depth of flow upstream of the bridge assuming that the pier coefficient of drag is 1.2. Drag Force CD Af (V1^2)/2 CD=1.2
Determine the velocity of flow find the discharge in cfs : Given a V-shaped channel with a bottom slope of 0.001, a top width of 12ft, and a depth of 6 ft, determine the velocity of flow. Find the discharge in cfs and m^3/s.
Determine the max velocity and acceleration of b : A brass (nonmagnetic) block A and a steel magnet B are in equilibrium in a brass tube under the magnetic repelling force of another steel magnet C located at a distance x=.004 m from B

Reviews

Write a Review

Civil Engineering Questions & Answers

  Describe a piece of john deere agricultural equipment

Describe a piece of John Deere agricultural equipment that utilizes GPS hardware and software. Describe how many RECs are placed on the equipment and where it is placed.

  How much will be in the account at the end of 5 years

If you deposit $1000 per month into an investment account that pays interest at a rate of 6% per year, compounded quarterly, how much will be in the account at the end of 5 years

  How many months will take to have the clay settle 3 inches

A 10 ft layer of normally consolidated saturated clay is found at depth of 20 ft beneath a formation of partially saturated sandy silt with unit weight of 115 lb/ft cubed. Void ratio of the clay is 1.5 and specific gravity is 2.6.

  Determine the heights of the fluid columns for barometers

Determine the heights of the fluid columns for barometers that use the following liquids at 20 C: water, ethyl alcohol, and mercury. Why do you think mercury barometers were used in the past (before the negative health effects of mercury were know..

  Determine thethickness of the water layer under the runners

A sled with two runners slides along a thin horizontal layer ofwater between the ice and the runners. The horizontal force thatthe water puts on the runners is equal to 1.2 lb when the sled'sspeed is 30 ft/s.

  Determine the rate at which heat must be transferred to the

Saturated liquid water at 1.0 MPa is throttled adiabatically to a pressure of 0.4 MPa. If the change is kinetic energy is negligible, what percentage of the water evaporates during this throttling process?

  Divide the sodium hydroxidecharge into 10 smaller charges

Divide the sodium hydroxidecharge into 10 smaller charges, and add them one at a time, makingsure that each is well mixed and the tank temperature has stoppedincreasing before adding the next charge.

  When would the wells start interfering with each other

Two pumping wells 1,000 m away fully penetrate the same confined aquifer. One of the wells pumps at a rate of 1240 m3/ day and the second well pumps at 850 m3/ day.

  Determine the tensions in the cables and the reactions

The suspended load exerts a force F = 600 lb at A and bar OA weighs 200 lb. Assume that the bar's weight acts at its midpoint. Determine the tensions in the cables and the reactions at the ball and socket support O.

  Determine the daily discharge per 1000 feet into the river

A canal was constructed running parallel to a river 1500 ft away. Both fully penetrate a sand aquifer with a hydraulic conductivity of 1.2 ft/d. The area is subject to rainfall of 1.8 ft/y and evaporation of 1.3 ft/y.

  Design a cantilever beam made of reinforced concrete

Design a cantilever beam made of reinforced concrete. The rectangular beam is 18 ft long and subjected to a uniformly distributed dead load of 1.5 kip/ft (not including the beam weight)

  Calculate the modal split in percentage for the given value

A calibrated utility function for travel in a city by three modes (car, bus, and light rail) is where X is the cost of travel (cents) and Y is the travel time in minutes. Use logit model to calculate the modal split (in percentage) for the given valu..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd