Calculate the velocity of the puck

Assignment Help Mechanical Engineering
Reference no: EM13888278

A 0.16 kg hockey puck (rubber disk) is moving on an icy, frictionless, horizontal surface. At t =O, the puck is moving to the right at 3.0 mis. Calculate the velocity of the puck (magnitude and direction) after a force of 25 N directed to the right has been applied for 0.05 sec.

Reference no: EM13888278

Questions Cloud

Write an assignment on different characteristics of scale : Write an assignment on different characteristics of scale types
Why is real time processing essential in an erp system : Why is real time processing essential in an ERP system?
Magnitude of the change in momentum : Find the magnitude of the change in momentum of the ball and of the impulse applied to it by the bat.
Describe how erp systems enhance efficiency in a business : Describe how ERP systems enhance efficiency in a business organization.
Calculate the velocity of the puck : A 0.16 kg hockey puck (rubber disk) is moving on an icy, frictionless, horizontal surface. At t =O, the puck is moving to the right at 3.0 mis. Calculate the velocity of the puck (magnitude and direction) after a force of 25 N directed to the righ..
Chacon university potential problems in an erp : Chacon University potential problems in an ERP implementation.
Erp implementation at zostner industries. : ERP Implementation at Zostner Industries.
Create a visual representation of the data flow : Create a visual representation of the data flow based on the systems development life cycle and what is the estimated amount of time for implementation
How does this relate to nutrient cycles : Of all the naturally occurring elements in the biosphere, why have the cycles of carbon, nitrogen, and phosphorus been so intensively studied by ecologists?

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Ball bearings uses oil whose viscosity ranges

A pump fitted with 50mm bore ball bearings uses oil whose viscosity ranges from 100cSt at cold pump start-up to 7.5Cst when running at maximum speed and load. If these viscosities are the safe limits for the oil, specify the maximum start-up speed an..

  A 20 mm diameter steel bar is to be used as a torsion

a 20 mm diameter steel bar is to be used as a torsion spring. if the torsional stress in the bar is not to exceed 100

  A 120 lbf 534 n skydiver is free-falling at an altitude of

a 120 lbf 534 n skydiver is free-falling at an altitude of 6500 ft 1980 m. estimate the terminal velocity in mph for

  Determine the principle stresses and the maximum shear

a post-hole digger is mouted on a tractor. the power unit of the machine applies a torque of 800 lb.in to the auger and

  In a rankine cycle with reheat steam at 500c expands in a

in a rankine cycle with reheat steam at 500c expands in a high pressure turbine until it reaches the saturated vapor

  A bullet of mass 81gm and moving with a velocity of 300msec

a bullet of mass 81gm and moving with a velocity of 300msec is fired into a log of wood and it penetrates to a depth of

  For a turbine efficiency of 86 determine a the amount of

air enters the compressor of a regenerative gas-turbine engine at 300 k and 100 kpa where it is compressed to 800 kpa

  Determine the maximum speed

A vehicle of mass 1500kg and track 1.8m has a centre of mass located centrally at 1,1m above the ground. It has to travel around a bend of 56m radius to the centre of mass.

  Estimate the minimum collector area ft2 required for a

solar energy is used to warm a large collector plate. this energy in turn is transferred as heat to a fluid in a heat

  Determine the rate of energy transfer from the air to water

Water enters one stream of an unmixed stream heat exchanger at 20°C and increases in temperature by 10°C. Air enters the second stream on the heat exchanger at 400°C and 5 kg/s. The air temperature at the exit of the heat exchanger is 200°C cooler th..

  Problem 1heat is being generated uniformly throughout a

problem 1heat is being generated uniformly throughout a sphere at volumetric rate 4. the radius of the sphere is r and

  A rigid 10m3 tank contains water initially at 120 c with 60

a rigid 10m3 tank contains water initially at 120 c with 60 liquid and 40vapor by volume. a pressure-relief valve on

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd