Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
a 4ft-long, 1-in-diameter shaft rotates inside an equally long cylinder that is 1.02 in. in diameter. Calculate the torque required to rotate the inner shaft at 2000 rpm if SAE-30 oil at 70 degrees F fills the gap. Also, calculate the horsepower required. Assume concentric cylinders.
A tension specimen has a gauge length of 8 inches and a diameter of .505 inches. A load of 9580 pounds was found to develope a stress in the specimen equal to the proportional limit of materials. ( assume that the proportional limit and the yield ..
Thin rubber strips are used to provide increasing resistance to orthopedic patients during large motion exercises. The sheets shown are 0.03125 in thick and 3 in. wide. Say the rubber properties are 120 psi and v= 0.47.
The soil will be excavated from the borrow pit, moistened to increase the water content to 13.5% (assume i will not change the volume of solid mass) and then compacted to a final dry unit weight of 118 pcf.
The storage in a reach of river is 20,000 m^3 at a given time. Determine the storage 1 hr later if the average rates of in flow and out flow during the hour are 20 and 18 m^3/s, respectively
A mason contracted with a general contractor to build an exterior wall from 8-inch CMUs. The wall is 82 feet long and 8 feet high.16The mason must finish the wall in 3 days and gets paid $4 per block.
A simply supported beam is to span 12 feet. It will support a uniformly distributed load of 800 pounds per linear foot over the full span and a concentrated load of 1000 pounds acting at 4 feet from the left support.
Determine the required dimensions. The inside diameter is to be two- thirds of the outside diameter. The allowable shearing stress is 70 MPa, and the angle of twist is not to exceed 4 degree in 3 m of the shaft.
A froth flotation process is used to concentrate copper ore. It is a two stage process with a rougher stage followed by a cleaner stage. The cleaner tailings are returned to the rougher flotation.
You have two wires connected end to end. Wire 1 is copper and wire 2 is made using a special carbon conductor. Wire 1 has a resistance of 0.215 ohms/ft and is 500 ft long. Wire 2 has a resistance of 0.141 ohms/ft and is 700 ft long.
you measure the average headway and average spacing of passing vehicles as 3.2 seconds and 165 ft, repsectively. calculate the flow, average speed, and density of the traffic stream in this lane.
Determine the compressive strengths of the following
The buses are run by independent drivers, however, who make no attempt to coordinate their schedules. Actually, one bus runs slightly faster than the other so that over many trips the fraction of trips that the second bus leaves within a time t
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd