Calculate the time interval between air photo exposures

Assignment Help Civil Engineering
Reference no: EM13310680

Air photos are taken with specified overlap to take advantage of image parallax. Calculate the time interval between air photo exposures if the ground speed of the aircraft is 160km/h, the focal lenght is 50mm, the format (this is the film dimension, not the dimension of the developed image) is 70mm, and the photographic scale is 1:500, and the forward overlap of successive images is 60%.

Reference no: EM13310680

Questions Cloud

Determine what is the effective stress 25 feet deep : What is the effective stress 25 feet deep if the specific weight of the dry soil (dry unit weight) is 120 pcf and the water table is 12 feet deep
Determine void ratio and unit dry weight of soil particles : A 110 cm^3 sample of wet soil has a mass of 106 g and a degree saturation of 100%. When oven-dried, the mass is 81 g. Determine the 1) water content, 2) specific gravity, 3) void ratio, and unit dry weight of soil particles.
Determine the rest mass of the polonium nucleus : A polonium nucleus, while at rest, decays into a lead nucleus of rest mass 342.1126 x 10^-27 kg, and emits a helium nucleus of rest mass 6.6483 x 10^-27 kg. Determine the rest mass of the Polonium nucleus
What is the concentration of the chemical leaving pfr : We have a batch reactor ( r = -k1) with volume of V1. The concentration entering the batch reactor is Co. The batch reactor is operated from t =0 to t = t1. After that the water exits the batch reactor and enters a PFR (r = -k2C) wi..
Calculate the time interval between air photo exposures : Air photos are taken with specified overlap to take advantage of image parallax. Calculate the time interval between air photo exposures if the ground speed of the aircraft is 160km/h, the focal lenght is 50mm
Explain which are hybrid orbital the carbon at the molecules : which are hybrid orbital the carbon at the following molecules a, H3C-CH3 b, H3C-CH= CH2 c, CH3-C Tripl bond C-CH2OH d, CH3CH=O
How much energy goes into the battery : Batteries are recharged by connecting them to a power supply (i.e., another battery) of greater emf in such a way that the current flows into the positive terminal of the battery being recharged
Calculate the maximum acceleration bungee experiences : A 55 KG bungee jumper leaps from a bridge. She is tied to a bungee cord that is 12 m long when unstretched, and falls a total of 31 m. Calculate the spring constant of the bungee cord assuming Hooke's law applies.
Find out electron domain and molcules : Using vsepr molcule determine Electron Domain and Molcules for. CH3I ClF3 H2S SO3 SO4^-2 Nh4 NH2^- CO3^-2 ICI2

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the maximum service load

Determine the maximum service load W (kips) at the mid-height of the beam-column shown in the accompanying figure 2.1. Assume the member is hinged with respect to bending in both x and y directions at the top and bottom.

  What is the carbon concentration at 4 mm below surface

A 1045 steel will be heat treated in air at 900 C. What is the carbon concentration at 0.4 mm below the surface after 6 hours

  Find the height and the width of the triangular soil bank

The soil's angle of repose is 35° and its swell is 25%. Find the height and the width of the triangular soil bank that will result from the trench excavation

  Elevation of the curve turning point

Set up a table showing curve elevations at the PVC, at the PVT, and at the half-station points along the curve. Compute the station and elevation of the curve turning point.

  Find the maximum axial tension using lrfd

No incisions are noted. Find the maximum axial tension using LRFD. Can we resist the same force in compression if the member is 10ft long?

  Calculate horizontal force required to hold hose in place

Diameter of the hose and the nozzle are .25ft and .1ft respectively. If the pressure inside the hose is 60 psig and the flowrate is 1.2 ft^3/s, calculate the horizontal force required to hold the hose in place.

  Determine the saturated hydraulic conductivity of the layer

This uniformly reduces 4X10-4 cm / s to a depth of 22 meters. If the water level is about 3 feet below the surface, determine the saturated hydraulic conductivity of the layer.

  Absolute pressure of the carbon dioxide in the can

The circular top of a can has a radius of .0320m. the pull-tab has an area of 3.8x10^-4 m^2. The absolute pressure of the carbon dioxide in the can is 1.40x10^5Pa. find the force that these gas generates on the top of a can?

  How do the crack behaves under the compression

how do the crack behaves under the compression of a concrete cubes under friction between the plates and specimen with stress strain diagram?

  Hydrograph for a watershed having a drainagearea

For the data given below, derive the 2-hr unit hydrograph for a watershed having a drainagearea of 216 km^2, assuming a constant baseflow of 20 m^3/s.

  Determine the forces acting on member bh

The force exerted by the potatoes on the frame at one side of the chair is equivalent to horizontal and vertical forces of 24 N and 84 N, respectively, at E and a force of 28 N perpendicular to member BH at G.

  Determine the pressure head at the nozzle inlet to produce

determine the pressure head at the nozzle inlet to produce a water jet velocity of 40 ft/s. Neglect the friction loss and assume incompressible flow.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd