Calculate the the phase voltages and the phase currents

Assignment Help Electrical Engineering
Reference no: EM13229344

A 345-kV, 3-phase transmission line delivers 100 MVA, 0.866 lagging, to a DELTA connected load. Calculate the following: a.) The total real and reactive power delivered to the load. b.) The real and reactive power per phase. c.) The phase voltages. d.) The phase currents. e.) The phase impedances. f.) The line currents.

Reference no: EM13229344

Questions Cloud

Prove that the electrons will not reach the positive plate : Electrons are liberated with zero velocity from the negative plate of a parallel plate capacitor, to which is applied a magnetic flux density B parallel to the plates. Prove that these electrons will not reach the positive plate.
Find angle with respect to b at which it reaches equilibrium : A small magnetic needle, which is free to turn slowly in a horizontal plane, is placed at the center of the coil in question (6). Show that it will set at an angle \(\phi\) to B where \(cot(\phi) = 4R/(\pi n^2 \mu_{o}\omega a)\)
Explain the ammonium content using gravimetric analysis : As part of a soil analysis on a plot of land, you want to determine the ammonium content using gravimetric analysis with sodium tetraphenylborate, Na B(C6H5)4-. Unfortunately, the amount of potassium, which also precipitates with sodium tetrapheny..
Calculate the emf between the center of the disk and its rim : A plane circular disk of radius 0.25m rotates at a speed of 200 rad/s about an axis through the center of the disk perpendicular to the plane of the disk. There is a uniform magnetic flux B = 1 Tesla parallel to the axis of rotation.
Calculate the the phase voltages and the phase currents : A 345-kV, 3-phase transmission line delivers 100 MVA, 0.866 lagging, to a DELTA connected load. Calculate the following: a.) The total real and reactive power delivered to the load. b.) The real and reactive power per phase.
Compute the frequency of the loght corresponding : Calculate the frequency of the loght corresponding to the lowest energy pure virational and pure rotational transitions. In what regions of the eletromagnetic spectrum do the transitions lie?
What is the underlying problem associated with the lease : Advise Wilma and Mary in respect of each of the above concerns - What is the underlying problem associated with the lease on the premises of Wilmary Books and how would you resolve it as part of your merger proposal?
What is the approximate maximum position uncertainty : use GPS and they are useful for many reasons. GPS receivers use signals from more than three satellites so that cheap quartz clocks can be used instead of expensive atomic clocks. The quartz clocks tend to drift up to + or -1 ns/s.
Explain balance equation for the combustion of ethanol : Using the balance equation for the combustion of ethanol, anwer the following question C2H6O(l) + 3 O2(g)-----------2CO2 (g) + 3H2O(g) Ethanol

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the output voltage produced

A 6-bit DAC has an input 1001012 and uses a 10.0-V reference.

  What is the after-tax investment value of the machine

A corporation purchased a machine for $60,000 five years ago. It had an estimated life of 10 years and an estimated salvage value of $9,000. The current book value of this machine is $22,500. If the current market value is $40,000.

  Find the voltage at coil 2 and the flux through coil 1

Two coupled coils have self-inductances L1 = 50 mH and L2 = 200 mH, and a coefficient of coupling k = 0.5. If coil 2 has 1000 turns, and I1 = 5Sin (400t) (i.e. the phasor current is 5? -90° A). Find the voltage at coil 2 and the flux through coil ..

  What is the equilibrium hole concentration

A Si sample is doped with 10^17 As atoms/cm^3. What is the equilibrium hole concentration P0 at T=300K?

  Explain complex power

Question about Complex power, If an electrical load operates at 240 Vrms.The load absorbs an average power of 8kW with .8 lagging power factor

  Design a compensator using one stage of lead compensation

1. Determine the minimum value of gain K when Gc(s)=K, so that the steady-state effect of a unit step disturbance Td(s)=1/s is less than or equal to 5% of the unit step (y(inf)=0.05). 2. Determine whether the system using the gain of part 1 is stab..

  Compute the mechanical energy of the turbine

A natural gas power plant has a condenser that extracts 28,000 Btu/kg of natural gas. Compute the mechanical energy of the turbine and the overall system efficiency

  What is the peak output voltage with feedback

3) If the input voltage to a Full-Wave Bridge Peak Rectifier is vi(t) = 10.4sin(600t) Volts, what is the peak output voltage. Assume all diodes have a 0.7V drop, (ie. VD = 0.7V). 4) For the previous problem, if the resistor in the circuit is equal t..

  Determine what is the source current

An input signal of 10V at 0o is applied to a parallel RLC circuit with resistor R = 100 , inductive reactance XL = 200 , and capacitive reactance XC = 200 . All three components are connected in parallel to the source.

  Obtain the impulse responses of the systems

(a) The ideal delay system. y[n] = x[n-nd] (b) The accumulator system. y[n] = sum (xk) , k from -inf to n (c) Forward difference system. y[n] = x[n + 1]- x[n] (d) Backward difference system. y[n] = x[n]- x[n - 1]

  Examining harmonic content of ac voltage waveforms

Analysing harmonic content of ac voltage waveforms, An a.c. voltage, V, comprises of a fundamental voltage of 100 V rms at a frequency of 120 Hz, a 3rd harmonic which is 20% of the fundamental

  Write the expression for the current

Write the expression for the current through the capacitor after the switch is closed. The circuit is a 60 Volt circuit

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd