Calculate the temperature during the isothermal procession

Reference no: EM13668919

A cylinder by a piston contains .250 mol of ideal oxygen at a pressure of 2.40 x 10 5 Pa and a temperature of 355K.The gas first expands isobaric ally to twice its original volume. It is then compressed isothermally back to its original volume and finally it is cooled isochoric ally to its original pressure. A) Show the series of process is on a PV diagram. B) Calculate the temperature during the isothermal procession. C) Calculate the maximum pressure. D) Calculate the total work done by the piston on the gas through the series of processes.

Reference no: EM13668919

Questions Cloud

Decide the speed of each disk after the collision : Two shuffleboard disks of equal mass, one orange and the otheryellow are involved in a perfectly elastic glancing collision. The yellow disk is initially at rest and is struck with the orange disk moving initially to the right at 5.70m/s.

How many radians has the wheel turned through the interval : An electric motor rotating a workshop grinding wheel at a rate of 118 rev/min is switched off. Suppose the wheel has a constant negative angular acceleration of magnitude 2.20 rad/s2.

Discover the drill''s angular acceleration : A dentist's drill starts from rest. After 3.50 s of constant angular acceleration it turns at a rate of 2.4*104 rev/min. Discover the drill's angular acceleration.

What is least number of lines per centimetre for grating : A grating gives no third-order spectrum for any part of the visible spectrum (700 nm – 400 nm). What is the least number of lines per centimetre for this grating?

Calculate the temperature during the isothermal procession : A cylinder by a piston contains .250 mol of ideal oxygen at a pressure of 2.40 x 10 5 Pa and a temperature of 355K.The gas first expands isobaric ally to twice its original volume. It is then compressed isothermally back to its original volume and..

Bullet remains in block and after the impact block lands : An 8.00 g bullet is fired into a 230 g block that is initially at rest at the edge of a table of 1.00 m height. The bullet remains in the block, and after the impact the block lands d = 1.8 m from the bottom of the table. Decide the initial speed of ..

How much mechanical energy is lost in the collision : A 1200 kg car traveling initially with a speed of 25.0 m/s in an easterly direction crashes into the rear-end of a 8200 kg truck moving in the same direction at 20.0 m/s. The velocity of the car right after the collision is 18.0 m/s to the east. What..

The average speed of a nitrogen molecule in air : The average speed of a nitrogen molecule in air is about 669 m/s, and its mass is 4.43×10-26 kg. If it takes 2.66×10-13 s for a nitrogen molecule to hit a wall and rebound by the same speed but moving in the opposite direction, what is the magnitude ..

An unknown mass of silver is pulled from a furnace : An unknown mass of silver is pulled from a furnace where its temperature was 900C and placed on a very large block of ice at 0.0C. Assuming that all the heat given up with the silver is used to melt 1.3 kg ice and not all the ice melts, what is the m..

User Account

All Pages