Reference no: EM13250604
Assessment
For each circuit and its analysis there should be graphs shown (in Word) and conclusions drawn about the circuit operation (c.f laboratory write-up).
1. Draw a circuit of a DC power supply having a 20 V (10 V + 10 V) centre-tapped transformer secondary and using a full-wave rectifier. Each secondary winding has a resistance of 0.5 Ω, the smoothing capacitor is 4700 μF and the load is 15 Ω. Use 1N4001 diodes.
(a) From the output voltage variation during turn-on calculate the turn-on time constant.
(b) Calculate the steady-state DC (average) output voltage and the peak to peak output ripple voltage. Include graphs.
2. A resonant circuit comprising a 1 mH inductor, a 100 nF capacitor and a 10 kΩ resistor, all connected in parallel, is driven from a source having a 100 kΩ resistance.
(a) Measure the centre (resonant) frequency of the circuit and its voltage gain (in dB and as a ratio) at this frequency.
(b) Describe the circuit's response to a 4 Vpp sinusoid. Measure its time constant.
(c) Describe the circuit's response to a 100 Hz, 10 Vpp square wave centred on 0 V.
|
Determine the self inductance of each coil
: An iron ring with a 50-cm mean diameter has a square cross-section of 4 cm2. It is wound with two coils having 1000 and 400 turns. Calculate (a) the self inductance of each coil, and (b) the mutual inductance between them.
|
|
Which of the following is considered to be the most negative
: Which of the following is considered to be the most negative political tactic?
|
|
Find the inductance of the solenoid
: A 297 turn solenoid has a radius of 5.00 cm and a length of 20.0 cm. Find the inductance of the solenoid
|
|
Explain a mixture containing 9 mol of f2
: A mixture containing 9 mol of F2 and 4mol of S is allowed to react. This equation represents the reaction that takes place. 3F2+S-->SF6
|
|
Calculate the steady-state dc output voltage
: Describe the circuit's response to a 4 Vpp sinusoid. Measure its time constant and describe the circuit's response to a 100 Hz, 10 Vpp square wave centred on 0 V.
|
|
Discuss the requirements for directional-adaptive
: Discuss the requirements for directional, adaptive, market entry, and competitive strategies?
|
|
Determine the line and phase voltages
: A Y-connected load with an impedance of 12 - j15 per phase is connected to a balanced Delta-connected 208-V, 60-Hz, three-phase, positive phase-sequence supply. Determine (a) the line and phase voltages
|
|
Explain what is the metal
: A 2g sample of an unknown metal, M, was completely burned in excess O2 to yield .02224mol of the metal oxide, M2O3. What is the metal
|
|
Utilizing health facilities
: You as a consumer of health care have certain expectations when utilizing health facilities. In addition to receiving a friendly greeting, what are your expectations pre-service, point of service, and after-service
|