Calculate the starting current offering max points

Assignment Help Electrical Engineering
Reference no: EM13255690

A 440-V, 60Hz, 4-pole, delta connected three phase induction motor has the following parameters in ohms/phase.

R1= .3, X1= .9, R2=.6, X2=.9 Rc=150, Xm=60

If the rotational losses are 6% of the developed power

A.) determine the efficiency when it runs at 3% slip.

B.) Calculate the starting current offering max points and will give a 5 star rating

Reference no: EM13255690

Questions Cloud

Which of these below is not one of these aspects : Which of these below is NOT one of these aspects?
Effect on your final carbonate if a drop of hcl is spilled : What will be the effect on your final %carbonate if a drop of HCl is spilled, and is not delivered to the test tube? Explain reasoning.
Determine what should be the width of the microstrip line : Design a microstrip transmission line with Z0 =100 ohm that will be etched onto a sielectric substrate with er = 3 and a thickness of 4 mm. what should be the width of the microstrip line
What was the fans angular acceleration : A cooling fan is turned off when it is running at 880rev/min . It turns 1000 revolutions before it comes to a stop. What was the fan's angular acceleration, assumed constant
Calculate the starting current offering max points : A 440-V, 60Hz, 4-pole, delta connected three phase induction motor has the following parameters in ohms/phase. R1= .3, X1= .9, R2=.6, X2=.9 Rc=150, Xm=60 If the rotational losses are 6% of the developed power A.) determine the efficiency when i..
Compute the effective temperature of jupiter : how do you calculate the effective temperature of jupiter if the sun is its only source of heat given that jupiter is 7.8*10^8 km from the sun and has an albedo of 0.73
What is the internal growth rate : Healthy Foods has total assets of $124319, net fixed assets of $79775, long-term debt of $51692, and total debt of $78769. If inventory is $31,800, what is the current ratio? Round your answer to two decimal places.
How far is the center of gravity from the front wheels : A truck has its front wheels (only) driven onto a scale and a reading of 3000 kg is obtained. How far is the center of gravity from the front wheels
Calculate the depreciation expense : Calculate the depreciation expense. (Do not round intermediate calculations and round your final answer to nearest whole dollar amount.)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the maximum amount of transmissions per hour

A mote draws an average of 200mA when "awake", 0.1mA when "sleeping", and 400mA (total) when "transmitting". Transmitting data takes 2ms, and sensor acquisition takes 1ms. If the maximum size battery available is 5000mAh

  At what time t2 has 50 percent of the initial energy stored

A 190-F capacitance is initially charged to 1190V . At t = 0, it is connected to a 1-k resistance.  a) At what time t2 has 50 percent of the initial energy stored in the capacitance been dissipated in the resistance

  Find the total voltage drop in 200 twisted pair wire

A proportional controller for a rotating antenna has a gain Kp of 5 in-oz/deg. The antenna was initially pointing due south, but was then commanded to point southeast. Find the initial torque supplied to the antenna.

  What are the expressions for the transmitted signals

Message signal m(t) = 0.6sin(27r3000t + pi/9) For a carrier signal with amplitude Ac = 4,fc = 40MHz, What is the signal bandwidth if we use AM with ka = 0.7 DSB-SC FM with kf = 5000 - HZ/V

  Design the circuit od sequences using d flip-flops

Draw the state diagram for a sequence that detects the sequence 0101 using a minimal number of states. The detector should also detect overlapping sequences. Design the circuit using D flip-flops. Draw the logic diagram.

  Determine the frequencies of aliasing noise

a. Sketch the spectrum of the original signal and the sampled signal from 0 kHz and 25 kHz. b. Sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal.

  Find the modulation index and percentage of modulation

An AM transmitter radiates 9 kW of power when the carrier is unmodulated and 10.125 kW when the carrier is sinusoidally modulated. Find the modulation index, percentage of modulation.

  Find phase a current ia using fourier techniques

Open Neutral Assume that the load is star connected with the neutral disconnected. Each phase has a series RL load with R = 5 ohms and L = 20 mH. Plot the neutral voltage Plot the phase to neutral voltage for phase a.

  Explain power factor

Power Factor, A single phase electric motor has an output power of 10 kW and an efficiency of 90% at full load. The motor is fed from a 240 V supply via a cable that has a resistance of 10 milli ohms per metre length.

  Does current enter fo leave positive terminal of inductor

Teh energy stored in a 2H inductor os 130 J and is increasing at 200 J/s at t=4s. A) Determine the current magnitude at t=4s. B) Determine the voltage magnitude at t=4s.

  What rf bandwidth is required to send the data using qpsk

What RF bandwidth is required to send the data using QPSK? If the RRC filters in the transmitter and receiver are replaced with ones that have ? = 0.20, what are the new RF bandwidths in parts (a) and (b)?

  Sketch the spectrum of the original signal nd sampled signal

a. Sketch the spectrum of the original signal and the sampled signal from 0 kHz and 25 kHz. b. Sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal. X(f) 10k 2..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd