User Account

All Pages

Calculate the resistors resistance

Assignment Help Electrical Engineering
Reference no: EM13218552

The noise produced by a resistor is to be amplified by a noiseless amplifier having a voltage gain of 75 and a bandwidth of 100 kHz. A sensitive meter at the output reads 240 μV rms. assuming operation at 37°C, calculate the resistor's resistance. If the bandwidth were cut to 25 kHz, determine the expected output meter reading.

Reference no: EM13218552

Questions Cloud

Find the probability that receiver makes a decoding error : The receiver takes the three received bits and decides which bit was sent by taking the majority vote of the three bits. Find the probability that the receiver makes a decoding error.
Calculate the number of calls : i) Calculate the number of calls/hour/cell and the number of calls/hours/km2 ii) Calculate the number of users/hour/cell and the number of users/hours/channel iii) Find the modulation frequency for this system.
Determine the equilibrium price and quantity : In a given marker, demand is described by the equation QD=1800-10P and supply is described by QS=200+10P. A. Determine the equilibrium price and quantity. B. Determine the surplus or shortage that would exist if the price was set at $60 by the state.
What is the approximate area of the same chip : For a chip area with area 2cm x 2cm in a 180nm logic technology, what is the approximate area of the same chip when ported to a 32nm logic technology.
Calculate the resistors resistance : calculate the resistor's resistance. If the bandwidth were cut to 25 kHz, determine the expected output meter reading.
Calculate ziponias output from 2000 to 2006 : Calculate Ziponia's output from 2000 to 2006, assuming that its growth rate was 6% from 2000 to 2001 and then the growth rate fell by 1% point each year. Plot these point onto your graph from part (a). Is the slope of this graph constant.
Design a third-order butterworth highpass : design a third-order Butterworth highpass filter with fc=100 Hz and high frequency gain of 20 dB using the standard form of the third-order Butterworth polynomial (s+1)(s^2+s+1)
Calculate the wavelength : The surface of the sun has a temperature of 6000 K. Calculate the wavelength at which the sun emits its peak radiancy.
Calculate the income elasticity of demand for x : in the following two panels, the demand for good x shifts due to a change in income (panel A) and a change in the price of a related good Y (panel B). holding the price of good X constant at $50, calculate the following elasticities

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define dynamic ram that must be given a refresh cycle

Dynamic RAM that must be given a refresh cycle 64 times per ms. Each refresh operation requires 150 ns. memory cycle requires 250 ns.

  Finding appropriate source for the electrical load

Finding appropriate source for the electrical load, Have four circuits. One takes 9Vdc, two 5Vdc, and last one takes 12Vdc. Have variable transformer for source. How do I calculate or choose the voltage needed to run all four circuits with out blo..

  Calculate inductance of sensor for air gap

calculate inductance of sensor for air gap of 1mm and 3mm?

  Deduce expression for power in terms of the line voltage

Show that the power in a three-phase, three-wire system with balanced loads is constant at every instant. Deduce an expression for the power in terms of the line voltage, line current, and the power-factor.

  The condition on the sampling period is determined

Finding the periodicity in N of the discrete time signal x(n) = Cos(3pi*Ts.n + pi/4) and then plotting the discrete signal. From this the condition on the sampling period is determined

  Draw the equivalent circuit referred

Consider the transformer to deliver its rated kilovoltamperes at 0.80 power factor lagging to a load on the low-voltage side with 240 V across the load. Find the highside terminal voltage.

  Derive a suitable sequential circuit

A sequential circuit has two inputs w 1 and w 2 , and an output, z. Derive a suitable circuit for the given condition.

  Need to use multisim and proteus

Need to use multisim and proteus and have build the circuit diagram on multisim and proteus, also have the program written, all u need to do its simulate it and take the necessary results.

  Interface binary i/o devices to the microcontroller

Interface binary Input Output devices to the microcontroller

  Solve using gauss-seidel method perform four iterations

Solve Using Gauss-Seidel Method (Perform Four Iterations) Using the Gauss-Seidel method and the initial guess X1(0)=1, solve the following equation (x_1)^2 - 6x_1 + 2 = 0

  Surface integral for jet engine

Surface integral for jet engine.  The air-gas exhaust velocity from a jet engine varies linearly from a maximum of 300 m/s at the center of the circular exhaust opening to zero at the edges. If the exhaust diameter is 1.6 m, find  thq  exhaust flow.

  Find the probability that the tenth phone installed

The probability that a person will install a black telephone in a residence is estimated to be 0.3. Find the probability that the tenth phone installed in a new subdivision is the fifth black phone.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd