Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 60 Hz, three-phase, transposed transmission line has the following parameters: Z = 13.114+ j52.952, Y = j0.311/1000. The sending-end line-to-line voltage is 161 kV. The total receiving-end load is represented by ZL =143 with an angle of 36.8 degrees. a) Determine the recieving end line to line voltage b) Find the voltage regulation c) Compute the sending-end current d) Calculate the real and reactive power at the sending-end
Design a class - A transformer-coupled emitter-follower amplifier to deliver 10 W to an 8 Ohm speaker. The ambient temp is 25 C and the maximum junction temp is Tj max = 150 C. assume the thermal resistance value are dev-case = 3.2 C/W
design a circuit to sort a product which has 2 different color in two diffrenet boxes for example red and green apples no any microcontroller or microprossser are allowed. which color sensor is the best to have 5 volt output so a solenoid may work..
If a stepper motor has a step-angle of 7.5? , what digital input rate is required to produce a rotation of 10 rev/sec What will be the step-angle for a hybrid stepper motor with eight stator windings and ten rotor teeth
Write a sequence of instructions to initialize and run the timer to geneate an 800 baud rate clock. what would be the baud rate if the intial value of the timer was set to 9AH
A PWM unit is set-up with a pre-scale factor of 128. If the PWMPER register is loaded with 34 and the PWMDTY is loaded with 3, what are the resultant values for the output period and pulse width
You are designing a 2.4 GHz receiver with a 140 MHz IF. System design constraints require that the local oscillator power be minimized to reduce the potential for interference to other systems as well as to reduce the receiver power consumption.
A single-loop negative feedback system has the loop transfer equation: L(s) = Gc(s)G(s) = K(s + 2)2 / (s(s2 + 1)(s + 8)) a. Sketch the root locus for 0 K infinity to indicate the significant features of the locus.
1. Point charges Q1 and Q2 are respectively, located at(4,0,-3) AND (2,0,1). If Q2=4nC, find Q1 such that a. E at (5,0,6) has no no z component b. The force on a test charge at (5,0,6) has no x component
Construct a truth table for the following specifications: if any two consecutive switches out of four on-off switches in a row are on, then a light is on; otherwise, the light is off. Denote the switches in order as a, b, c, d,
b) find nonhomogeneous solution with method of undetermined coefficient with constants evaluated c) combine homogeneous soluton with nonhomogeneous solution to form the general solution calculate the unknown constant in homogeneous part
A baseband signal has frequency components from 5 kHz to 15 kHz. Determine (a) the theoretical minimum sampling rate and (b) the maximum time interval between successive samples.
A waveform generator is connected to an op-amp which has been setup as a voltage follower. The voltage follower is then loaded with a 50 Ohm resistor. What output impedance setting should the waveform generator use
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd