Calculate the rate enhancement caused by the enzyme

Assignment Help Civil Engineering
Reference no: EM13326437

An uncatalyzed reaction has a rate of 4.2 x 10-7 sec-1. When an enzyme is added the rate is 3.2 x 104 sec-1. Calculate the rate enhancement caused by the enzyme.

Reference no: EM13326437

Questions Cloud

How many hosts can there be in each subnet : Choose all the necessary and suitable MAC address, IP address for interfaces and port addresses implied by the above description.
Does stitching on ball have any influence on the trajectory : A baseball is hit from home plate and travels over the center field fence. What would the trajectory of the baseball look like if air-resistance was not factored in
Determine the net power delivered to the generator : Air enters the compressor at 98 kPa and 295 K at a rate of 10 kg/s and exits at 1 MPa and 620 K. Determine the net power delivered to the generator by the turbine.
Determine the velocity and the volume flow rate of the steam : Steam enters a nozzle at 400oC and 800 kPa with a velocity of 10 m/s, and leaves at 300oC and 200 kPa while losing heat at a rate of 25 kW. For an inlet area 0f 800 cm2, determine the velocity and the volume flow rate of the steam at the nozzle ex..
Calculate the rate enhancement caused by the enzyme : An uncatalyzed reaction has a rate of 4.2 x 10-7 sec-1. When an enzyme is added the rate is 3.2 x 104 sec-1. Calculate the rate enhancement caused by the enzyme.
What are biosynthetic pathways in cells anabolic produce atp : what are biosynthetic pathways in cells A) anabolic B) catabolic C) usually produce more atp than they consume D) release monmorsinto the cytoplasm
Find what are the probable genotype of the parent plants : Color in a type of squash is controlled by a single gene. The squash can be either white or yellow, with white squash (W) dominant to yellow (w). if 1/2 of the offspring are white, what are the probable genotype(s) of the parent plants
Determine the properties at the final state and the amount : Two tanks (Tank A and Tank B) are separated by a partition. Initially Tank A contains 2 kg of steam at 1 MPa and 300 ?C while Tank B contains 3 kg of saturated liquid-vapor mixture at 150oC with a vapor mass fraction of 50%
Find what is the velocity m per s in the upstream pipe : A pressure gage connected between the upstream pipe and throat section shows a pressure difference of 29 kPa. The gasoline velocity in the throat section is 14 m/s. What is the velocity (m/s) in the upstream pipe

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the values of stress and the change in thickness

A rectangular steel plate with thickness t=0.625 inches is subjected to normal stresses sigma x and sigma y.The strain in the x direction is known to be 0.00065 and the strain in the y direction is known to be 0.0004.

  Describing a dynamic programming algorithm

Describe a dynamic programming algorithm to find an independent set of T such that the sum of numbers of nodes in the set is the largest among all possible independent sets of T.

  What are the values of its density and specific volume

A certain gas weighs 16.0 N/m3 at a certain temperature and pressure. What are the values of its density, specific volume, and specific gravity relative to air weighing 12.0 N/m3

  Determine the carsvelocity and position when t

A car starts from rest and moves along straight line with anacceleration of a = (3s-1/3)m/s2, where s is in meters. Determine the car'svelocity and position when t = 6s

  What is the minimm work consumed by the compressor

A refrigerator compressor compresses 0.5 kg/s of saturated R-134A vapor at -10C to 1000 kPa and 50C. The compresser has a point that is not insulated and losess heat to the surroundings,

  Determine current supplied if final temperature is 70 degree

Now 300 kJ of heat is transferred to the refrigerant at constant pressure while 110-V source supplies current to a resistor within the cylinder for 6 min. Determine the current supplied if the final temperature is 70 degrees C.

  Operational changes to prevent river from contamination

assuming that the contaminant travels mainly by advection, propose any operational changes to the given layout to prevent the river from being contaminated.

  What is the average power that the system will use

Assume that Santa weighs 300 lbs, visits 10 houses an hour and requires a 20 foot lift at each house, what is the average power that the system will use if it is perfectly efficient

  Compute the convective heat transfer coefficent

Water at a flow rate of 1 kg/s is flowing in a pipe of internal diameter 5 cm. If the inside pipe surface temperature is 90 degrees C and mean bulk water temperature is 50 degrees C

  Determine maximum moment in the beam if spinned at both ends

If the live load on a 30 foot long beam is 1.2 kip/feet and the dead load is 0.8 kip/feet determine the maximum moment in the beam (kip-ft) if it is pinned at both ends. Assume the weight of the steel is 0.3 kip/feet.

  Compute the forces fh and fv on the dam and line of action

A dam has a parabolic shape z/zo = (x/xo)2, with xo = 10 ft and zo = 24 ft. The fluid is water, gamma = 62.4 lbf/ft3, and atmospheric pressure may be omitted.

  Create a vba function that will return the root of function

Create a VBA function that will return the root of the function e-x -x = 0 using the Newton-Raphson method. The input parameter for the function should be the initial guess for the root. Turn in your code for the VBA function.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd